AirVape Legacy Pro

gabs021

Member
Any day now, It's been shipped out from the factory
any way they will make to the south american market? I'm in Brazil and there are a few shops selling the Legacy Pro, but they all don't have a single acessory for it :(

I'm worried because the shipping alone from the airvape website gets a little expensive here to Brazil (40 dollars) so ordering just the capsules would get crazy expensive!! hopefully we'll get it in the brazilian market
 

felvapes

Well-Known Member
any way they will make to the south american market? I'm in Brazil and there are a few shops selling the Legacy Pro, but they all don't have a single acessory for it :(

I'm worried because the shipping alone from the airvape website gets a little expensive here to Brazil (40 dollars) so ordering just the capsules would get crazy expensive!! hopefully we'll get it in the brazilian market
We have the same issue in ausland
I usually try to buy all accessories when I buy the device so I save on post
It sucks when you have to buy a cheap part like screens for $5 and then have to pay $50 post on top lol

I will have to bite the bullet though for dosing caps as they will be a must have for me
 

gabs021

Member
Does anyone microdoses with the legacy pro? If anyone has experience with the dynavap and legacy, is it possible to vape small amounts like the amount we use with dynavap?
 
gabs021,

StringTheorista

Well-Known Member
Does anyone microdoses with the legacy pro? If anyone has experience with the dynavap and legacy, is it possible to vape small amounts like the amount we use with dynavap?
I use half-bowl dynavaps as my daily drivers. You absolutely can load a small amount in the airvape. Just make sure the whole bottom of the bowl is covered, so all the heated air you inhale in this convection device has to contact plant matter before it hits your lungs. No point inhaling just hot air 😉

That said, I use my ALP in on demand mode, so I load it more like a full dynavap tip, since that weed doesn’t cook unless I’m hitting it. This makes for less loading and unloading, and a bigger hit (more in bowl=more vapor). Also, while dynavap’s flavor hit is generally only the first one, flavor lasts much longer and is much better in the ALP, so there’s less benefit to a small load--you’ll get several good flavorful hits, whenever you take them
 

Dr. G

Vapman Collector*Vapman Beta Tester
Hi everyone, I just received my Legacy Pro. WOW. It is a beauty. I must admit I am looking forward to this when I come home tonight. Just looking inside at the improvements makes me very excited. Just on a visual...its really stunning. I really love this look. Anyway, just blabbing. Have a nice day everyone.


Well...I got home and used it.

Truly awesome. Thumbs up.
 
Last edited:

Puddentain

Well-Known Member
Hi everyone, I just received my Legacy Pro. WOW. It is a beauty. I must admit I am looking forward to this when I come home tonight. Just looking inside at the improvements makes me very excited. Just on a visual...its really stunning. I really love this look. Anyway, just blabbing. Have a nice day everyone.


Well...I got home and used it.

Truly awesome. Thumbs up.
I’m hoping that mine arrives tomorrow!
 

TeaCup

Well-Known Member
Ok my first questions. Is the issue with the mouthpiece that the ceramic one falls out of the rubber too easily, or that the entirety of the mouthpiece AND the rubber piece falls out of the ALP? And is there a way to extend the on demand timer before it turns the unit off? I like to stir by ritual, and every single time that I'm about to close the lid and take another hit, the unit turns off literally like 5 damn seconds right before I'm ready to go again. Frustrating. Yes, I know, worse case scenario.........stir faster!
 
TeaCup,

felvapes

Well-Known Member
Ok my first questions. Is the issue with the mouthpiece that the ceramic one falls out of the rubber too easily, or that the entirety of the mouthpiece AND the rubber piece falls out of the ALP? And is there a way to extend the on demand timer before it turns the unit off? I like to stir by ritual, and every single time that I'm about to close the lid and take another hit, the unit turns off literally like 5 damn seconds right before I'm ready to go again. Frustrating. Yes, I know, worse case scenario.........stir faster!
The silicone gasket is loose also and comes out as a unit with the MP
The OG is a bees dick bigger and fits nicely

With the timer it seems to stay on a while in between hits for me before turning off, would be plenty of time to stir I thought
Unless you mean the 1 min timer that only is on while you press the button

I hate stirring and find absolutely no benefit in the ALP
It seems to extract very evenly for me as is
There is the thinnest layer at the top that is lighter avb and the rest is the same colour throughout
But afaik there is no way to change the off timer in relation to your use/question
 

Okla68

Well-Known Member
Ok my first questions. Is the issue with the mouthpiece that the ceramic one falls out of the rubber too easily, or that the entirety of the mouthpiece AND the rubber piece falls out of the ALP? And is there a way to extend the on demand timer before it turns the unit off? I like to stir by ritual, and every single time that I'm about to close the lid and take another hit, the unit turns off literally like 5 damn seconds right before I'm ready to go again. Frustrating. Yes, I know, worse case scenario.........stir faster!
Session gives you the choice of 1, 3 and 10 minutes. On Demand burns for 1 minute at your Set temperature. It will heat as many times as it takes you to finish the load. The unit will Automatically Shut Off if No movement is felt for 3 minutes, regardless of the Mode set(Session or On Demand).
From what I can tell, as long as you are Moving the unit, it will continue to be Active for as long as you need to finish ON DEMAND. Session will run for the Set time(1,3,10) as long as it Isnt left laying Still for longer than 3 minutes at one interval.
 

jespar45

Well-Known Member
Been testing device for 3 days now and I am indeed impressed with performance. Very good taste, good power, fairly easy to use and clean, very good battery performance. Really liking it a great deal but there is one thing that's starting to piss me off is the damn power button. I have to try to turn it on for multiple times!!!
 

Okla68

Well-Known Member
Been testing device for 3 days now and I am indeed impressed with performance. Very good taste, good power, fairly easy to use and clean, very good battery performance. Really liking it a great deal but there is one thing that's starting to piss me off is the damn power button. I have to try to turn it on for multiple times!!!
? 1, 2, 3 !!!
3 Quick presses, good to go, here !
 
Okla68,

jespar45

Well-Known Member
Yeah for what ever reason the power button is a bit wonky. But I think I got the swing of it with my left thumb. Weird but as long as it turns on and off I'll gladly use left thumb.
 
Top Bottom