Yeah I'm pretty surprised by the speed and overall extraction quality. In the evening I used to have a couple bowls out of my Mighty and then maybe pack a Dynavap, P80 or my OG Legacy right before I sleep. I've noticed after 2 bowls in the Pro I'm significantly more medicated than with the Mighty. The Mighty is still very tasty for the first three minutes or so (usually I'm down around 330). But then the taste starts to fade and I'll have one or two at 360 and then one final puff at 390 to "finish it off". With the Legacy Pro I set it at 300 and maybe drop to 290 after the second hit. I'll let it go the full 5 minute session cycle and then (if I really feel like it) crank it up to 380 or 390 for a final draw. At this point the ABV is completely "vestratto" black-ish brown at the edge of combustion. If I do that last hit at 390 the herb is darker on the bottom. I've been packing the bowl fairly tightly to get the full hybrid effect, but If I crank it up quickly and take a big final draw that convection will hit the lower levels of the hard harder than the top. If I never do above 350, the roast is pretty even top to bottom and I don't see any green spots. The OG Legacy seemed to like a stir 3-4 minutes into a session to keep it even. And that was pain, considering how delicate you need to be to pack the bowl. Which brings up another point. The Pro is very easy to load. The bowl is a little wider than the OG but there it large area that slopes down toward the bowl. I can just pour some herb straight out of the grinder and use my finger to push excess from around the rim into the bowl.
These pictures should might help show what I'm describing. All those extra ridges on the OG meant I had to carefully load with a tiny scoop. In the bottom pic especially you can see the raised ring around the OG bowl, whereas the surround of the Pro is more like a smooth funnel.
On last thing about that oval/rectangular screen that guard the air intake. The screen is surrounded by black silicon ring/gasket that helps it sit flush in the intake hole. If you take it out to clean it, getting the silicon ring back about the screen is REALLY hard, especially if you're medicated. There don't seem to be deep enough grooves in the ring to easily "lock" the screen into. Took me about 10 minutes to get it back in, as I was exploring the device before I even used it once. Overall pretty minor complaint.
Still I'm pretty sure the weird temperature settings are going to piss off people like Troy that seem to take every vape and go straight to 420. Also keep in mind I'm in south Florida and it's be over 80º and very humid outside. Not sure how if that contributes but I usually find I that my comfortable vape temps are in the lower end of the spectrum for just about all my vapes.
