Search results

Picture 1 shows which part of the pointer needs to align with (be parallel with) the middle of the spring when it's in ‘resting’ position, as shown in Picture 2. If it's bent more to the left, then it's shifted and it'll max out a bit earlier. If it looks fine then there's a different problem

Remove the indicator housing and pull up the spring to release it from between the screw and 2 posts. The middle of the spring has to line up exactly with the part marked by the blue arrow and red line.

I’ve had the same happen just now, and it was a long burr along one of the slot. It was working fine if I loosened the screw slightly.

It's also possible that the pointer is bent along its length, which could cause similar issues. Make sure when you remove it to rotate it where there is a cut on the inner side of the wall.

Try to move the VI pointer with a pin to the maximum position, that might clear any small burr. Do you feel it's getting stuck on something? It should move smoothly with increasing tension.

Please check the note below the table. The temp 2 will combust if you leave it until timeout, use the wand temp 1 instead.

It will be on the way tomorrow

Yes, sorry, I've added the 4th step after making the video :doh: It's easier if you rotate it to the starting position. Push the adapter 2mm deeper. If it’s still not quite there, try adjusting it to 320°C or a little higher, and wait until the VI starts moving back before taking a draw. You...

They received the stock today, it should be on the way very soon.

If it’s in good shape, then it won’t make a difference. They’re all exactly the same length; the only slight difference is the angle of the middle end in relation to the outer end.

Yes I know, but when you switch rom C to F on the device those are the conversions and matching timers. Bending the middle end should help, but I don’t recommend it since it doesn’t make much of a difference other than shifting the end point. It won’t make it more “precise.” The current...

There are about 10 orders left which are missing reloads for some reason, I’ve shipped them yesterday and it should arrive to them on Monday. I expect those orders will be sent the same day or Tuesday. Sorry for the delay

Keep pushing the bowl into the stem while trying to unscrew the cap.

You can replace the o-ring that goes into the stem first to the 6*1mm size instead of the 5*1mm

Sorry about that, some early orders got out with burr in the tip connection. If the threads are damaging the o-rings then please try to deburr it like I do in the video with a metal or ceramic tweezer, around the inner edge marked in the picture. That’s where it usually tears up the O-ring. Then...

That won't work anymore unfortunately, how did it become black? At which part of the install did it you have to force it so much so that it got mangled? I'm trying to improve the manual of the install, maybe I missed something again. Send me an order no in PM please

It will be on the way in a few days, they should receive the stock tomorrow. Sorry for the wait.

4 months production + 2 months of QC + usual delays.

Bottom of the Manual

There was an update recently that the parcel got stuck at customs because they required a safety emissions report for the vapes, which was completed today. All orders placed up until last Wednesday should be on their way this week if they release the parcels soon.