Search results

Self pressed on the new dabpress setup! Fantastic quality, assuming low-mid 20s THC % but I have no data... it is PUMPING out rosin yields over 30% on small 1g presses, and I'm gonna do some larger presses later with some that has been sitting with Boveda. I expect great returns!

Typically, what are the THC levels in rosin? While I enjoy it a lot, I am not feeling the punch I get from other extraction methods.

Is buttering always a bad thing?

delete

There is nice stuff, and there is stuff that is on another level... I prefer the later. I want the skunkiest, cheesiest stuff that fills the room when you crack the lid. I want my eyelids to hang after my first pull. I want the top shelf.... nice just does not do it anymore.

It is difficult to find the language, is there a efficiency sweetspot for pressing certain amounts? Say, if I have 10g. Am I better off pressing it as one 10g cylinder, or two 5g cylinders? Is one way more efficient than the other? I have much love for this press and tons to type, but for...

Good to know,. I would have put near edge to promote drip but now I'll keep to the center. Grease Monkey is first up.

Wax vs Parchment paper. Which is the best for pressing?

Hoping to get my first press in tonight!

Strongway has arrived! Unfortunately I have one foot out the door and wont have a chance to dig in until tomorrow...

The right Humidity is critical. Most advice I read guides towards 62% as the optimum %. this article also might interest you: https://www.rosintech.com/live-rosin-vs-live-resin-whats-the-difference-how-to-make-live-rosin/

Fuck burn off. Set to red, enjoy the ride!

Yup... Those posts instigated this thread.

And all is well in the world!

LOL thanks y'all! ;) So glad y'all are onto a pump alternative!

The Eagle has landed! at 6 minutes till 10pm, the box landed on my door. I got it into the shop, put the box on its side, took my trusty box cutter, and slit the lid.... and fuck, the slick mat was directly under the tape. I cut right threw it.:bang: Damn! the rest of the unboxing was...

Yup... just logged back into Northern Tool to put in a backorder, and I see they have removed this item from their catalog/no longer available. Fuck. Seems like there are no budget pumps with a gauge, anywhere.

it is for those that have lots of material and want to melt faces.

This looks pretty slick! any plans to offer a 4 piece?

I am loosing faith the truck will deliver tonight... perhaps tomorrow.