Search results

White with black accents, like a storm trooper

Glass adapter is sold out on the link you provided from VPM. I. Hoping POV has them soon.

I just put a GrassHopper silicon mouthpiece protector over the V3 pro mouthpiece and place that on a 14mm to adapt to WP’s. It seals perfectly and works great! Still waiting for the V3 pro glass adapters to be available in US market.

FYI, The HR Fury 2 WPA fits in the V3 pro as you described. Also, a GrassHopper silicon condom fits over the V3 pro MP to mate to a 14mm water piece.

Anyone know where the glass MP’s are available for purchase in US?

I dunno. To me it seems like the problem is an electrical contact issue. Try unscrewing the torx screw slightly, then wiggle the top and bottom plates, then carefully line it all back up and tighten.

I think you probably should have posted in the main thread for the V3, but to answer your question, it seems to be normal. If you press and hold all 3 buttons and then shake, there is no rattle noise. If I shake my v3 without pressing and holding the buttons, there is a distinct rattle noise.

Starting from the left, 2 hits @420 mostly covered, 2 hits @420 uncovered, and temp stepping load. Am I right?

14

I saw his reply, but wanted clarification if the intakes were completely blocked as that will make a difference. There is a lot of resistance when doing so, but the temp buttons do lightly fluctuate.

When you are blowing into the MP, are you also covering the air intakes completely? If so, looks like this is as designed as my new unit also does this, but works fine otherwise. If the air intakes are uncovered, the buttons do not move.

Sounds like it’s time to start the return process?

IMO, to make the customer happy, they should have at least provided you with a replacement puck even if they found no issues when it arrived. Did you push back once they advised you?

I can add my 2cents here as I follow the same practice with just leaving the o-rings on when cleaning in ISO. I use warm ISO when soaking so it doesn’t require a very long soak to remove all the built up resin. I generally will only leave them submerged for 5-10 minutes at the most. I’ve had...

So I’ve been reading in the Mighty / Mighty barely + thread recently that many have switched to loading the oven full nug, no grinding method with good results. Maybe others have posted earlier in this thread about it , but I’ve been loading my TM the same with very good results using my RBT...

Lefty loosey! Just turn it left;)

They usually are added to the site at 9pm est on Sundays so you may want to try exactly at that time.

I happen to have a Grasshopper silicon mouthpiece and a 18mm male to 14mm female glass adapter at my vape station and found a good use for them. It’s a perfect seal on the OAB. It adds slight restriction and feels more natural inhaling. Has anyone tried this? https://ibb.co/MC9fDhk...

ISO soaking is completely fine on the ceramic pieces if you let them sit and evaporate the ISO for a few hours prior to putting back to use in your FW. This is my standard cleaning procedure and never noticed any ISO residual flavor, scent, or taste. ISO is used to clean electronics and will...

I would suggest searching classifieds for a pre-owned unit to save some $$ as I don’t think there have been many B-stocks in a while and not sure if there will be any more discounts.