1. What does SSTB mean? See our glossary of acronyms.
    Dismiss Notice

help with nitecore new i4 charger please

Discussion in 'Ask FC' started by chris 71, Mar 12, 2017.

  1. chris 71

    chris 71 Well-Known Member

    Messages:
    279
    can someone help me out with a nitecore new i4 intellicharger . i bought because my grasshopper still works it just doesnt charge . i took the grass hopper battery to the e cig vape shop were i bought the charger , the guy looked at the battery and said ya no prob i can charge it with this charger so i bought it .

    he said it was plug and play , so i figured i could just bring it home and throw the battery in and it will charge it at the right rate . but then i was reading the manual and it says you have to manually select for 3.7 volts which is what it says on the battery . but im having a hard time figuring out how to use the buttons on the charger to select the 3.7 . can i just put batteries in it without doing anything and will it charge propperly ?
     
    Last edited: Mar 12, 2017
  2. little maggie

    little maggie Well-Known Member

    Messages:
    2,442
    I'm not very technical but I have the nitecore and all my batteries are 3.7volts. I've just been putting them in the nitecore and have had no problems. I've been doing this with batteries for months and the batteries continue to work with no problem and my vapes have had no problem. When I look at the charged batteries in the nitecore most say 4.2 volts. Someone else may know whether this is unacceptable or not but, as I said, I've been using these with my milaana and any other battery operated vapes.
     
    Last edited: Mar 12, 2017
    ander and chris 71 like this.
  3. kazz

    kazz Little Lebowski Urban Achiever

    Messages:
    93
    I don't have experience with the Nitecore specifically, but would imagine an intelligent charger would be able to detect and charge at the correct voltage. 4.2 volts is the correct reading for a fully charged 3.7 volt battery.
     
    ander likes this.
  4. ander

    ander hardcore vapcapper

    Messages:
    386
    Location:
    mitteleuropa
    I have the Newi4 too. You don't have, since detection is automatic. But you can manually select a lower (or, but not recommended, higher...) charge level if you need to store them for long periods.

    Forgot: to switch voltage anyway, press C button to rotate the slots. Then hold V button until the green led moves up. Wait or press C again to exit.
     
    Last edited: Mar 16, 2017

Support FC, visit our trusted friends and sponsors