Recent content by BoxofRock

I wish I could show, these pictures of mine. Deep within they flow, maybe sometime..

Breathe a breath for me, it labors me to try. Open my eyes to life, death is all I see

its my bad not waiting to hear this, buying a preorder is just stupid when health is involved. I agree with the whole quote but this stands out in my case. All but one or two posts of my total was on this thread. I thought my complaining was for me of course but for the unheard lurkers as...

just the ID most times but the offset in the vapor tube when it goes by the battery the thinner the better

easy install bigvapes. the instructions are good and the vapor tube had a new metal mouthpc nipple. the vapor tube is 1/4 OD x 1/8 ID. I am going to get a few feet of it and replace rather than clean. It isnt a go to vape for me, its a med delivery when nothing else would be accepted I would...

I got my silicone replacements in two full weeks. Postmark in HK said they shipped right when he said it would. Its just that slow

funny you should say that. I put ver.2 silicone in and its a mixed bag. Out of the bag there was no odor and there is still cold odor on the old one. First toast and there is still plastic on the third draw and throughout thereafter. If you have follower my posts (bitching acually) the plastic...

the second generation silicone ring or oven isolation bushing appears to be a differant composition. It a solid white and no odor when cold. I will install later with new vapor tube, heat em up and see how it goes. Just thought I would throw that out there

if you rubberband it to the back its more of a feel but the flex will turn a question mark apperance. Kind of work in the far edge and working the flex roll it into place. I think it was covered earlier in this thread, and much better explained:\ Awhile back I just adjusted the flex to come...

Its to bad the metal nipple is to short to put tubing on. A lil longer piece of tube and it could extend outside the housing. But then thats a mod and use at your own risk:rofl: its such a subtle hitter seems not worth the hassle.

You need the chamber cap on and slip the mouthpc cap on for 5 seconds or so to reset. Once its charging or even heating you can take the chamber cap off. mailto:info@discreetvape.com is also an option but I bet if its a dud your best bet is customer service at GV

Welcome to FC, althou I am just a newbie really. I have been using an AroMed for close to 2 years and really enjoy it. I get vapor tube by the foot and bottle brush all the glass with just soap and water. Looks as thou most save the collections but I would rather op for as clean a vape...

I would like to see the puffit work out. I can see where I could use this at the dinner table in front of my mom and dad. They are in their late 80s and voted for mmj med laws but it another to sit across from a flamin blunt or glass bubblers. Exaggeration of course but just the same its real...

I believe its the silicone washer around the oven, not the tubing

FWIW