Dark Blue is so classy.
Will the pre order coloured T2's include a v2 wand adapter?
thanks ! for that tips. im at 350 C for hash and 290 C for flower.
I use the same position like for flower ( its almost at the middle, and works awesome). I take a small piece and press it betwen my thumb and indexfinger until i have a coin shape. I put it in between vape wool.For solid hash: 350-360C, set the new one adapter in a low position to ad a bit of conduction (That the tempest head protrudes about 2mm or so from the bottom of he wand). And remember to chop the hashish (i suppose you already do it)
What height is your tempest in the wand, maybe try setting higher, I prefer mine a little higher than in the manual
Too low probably, getting too much conduction from it is my guess. look at the picture in manual and adjust it like that
I'm also trying lower the level of roastines...adjusting Wand screw higher than recomnded and lowering the farhenheits on Wand.
i tried small pieces and one extra cotton layer. it worked very well, i extracted fast. It's a bit more fiddly, though. it needs further testing .
Are you going until timeout message or until the light stops flashing ?
Until timeout. What would be the setting if going until light stops flashing?
On the v2 the calibration housing locks the airflow setting. So you need to unscrew a little the housing, move it as you want, and then screw the housing again
It certainly is a pain to prepare, though some hash much harder than others. The ones that crumble into larger pieces, I do that only a flat hard surface, then once it's cooled down it hardens a little, and can be crushed gently into smaller fragments. Sometimes gently chopping it with a blade or similar breaks ti up fairly well. Bottom line is getting the best surface area to the volume, and the smaller the bits the better that is, plus the hot air flows better through the bowl giving a more even heating.
i use the zirc balls, and im just wondering if going till timeout is still a thing with the new adapter. it soaks so much less heat. i always let it in the wand still timeout though. i guess with the quarz balls you can reduce the heat further or use a gentler draw in the first seconds.
Do you know the temp setting on the Wand is really just a timer? So turning it up will just let the Wand continue heating for longer until timeout (and visa versa).
