Microdosing with Phase 3 ZX vs other ball vapes

simba

@weedanwine
There's no reason you couldn't put it in a bowl with the ZX. I bet that would be tasty šŸ¤¤

I'm using my Enano XL with hash, no issues. Sometimes I think people overthink using old skool hash in vapes. Usually the only issue is extra cleaning.
 
I've been reading about the ZX and it seems to be a brilliant piece of kit. I see it being touted as the best ball vape for microdosingā€¦. I have a ZX as a daily driver because it is so easy to use with small loads (~.03 g) but it is not the taste champ. That laurel belongs to a modded, PID controlled Elev8r.

I see it being touted as the best ball vape for microdosing. Is this because it genuinely performs better than other ball vapes with a smaller load or is it because the form factor of the ZX forces you into taking smaller doses? ... With my type of use, the ZX can run loads up to .024 g well, but preference hold the doses sizes well below that.

I already own a screwball and I'm loving it so far but I'm curious if the ZX would perform noticeably better than the SB with 0.1g loads or less. ... I don't know the SB, but based on their maximum to minimum load sizes, both the ZX and Elev8r both are good in the sub .1 g range in comparison to my other small load vapes.
There's a small dose or micro dose bowl for the Screwball now. Vapvana also have a microdose heater too now. I think it's called the pinch hitter. The small load bowl apparently works very well and appears to be one of Troy & Jerry's most used.
 
CreatureGlass,
Top Bottom