Product Tester / Reviewer
I have Atomizer is low message on the Wismec Reuleaux RX GEN3 Mod. Using Arctic FOX.
i am trying but no luck. let me clean it first with rubbing alchol and remove the oil. i can probably do it better that way. i will try once to make sure the heater wires are not loose. the screws i cant do anything about because they are already tight.Check the heater wires. They may be loose. First tighten the screws that hold them in with the little screwdriver that came in your kit from DT. Then check and see how much movement the hester has. Make sure the leads are pinched good by the screws for good contact.
Awesome post.Also, loosen the bottom pin a couple turns and re-tighten it after. Sometimes things are just loose or slightly out of place.