- Looks very good and the rubber material feels very sexy.
- It weighs 180g including the battery. Size 172x23.6mm. Battery is 2500mAh 20A
- Heating chamber is 18mm deep and 8mm in diameter. Holds 10% less than a solo/air. Grasshopper is 18.5x8.5mm
- Came with tool, brush, 3 spare shields for mouthpiece, spare mouthpiece, usb cable, charger, manual in de/en/es/fr. The shield for the bottom of the chamber was loosely lying in the chamber. I used the tool to push it to the bottom. Now it does not come out anymore
- It blinked 12 times to reach 160°C. I'll use a stopwatch tomorrow. Felt like 12 seconds
- Had to use the usb cable it came with to charge. My phone's micro usb was not long enough (it is only 6mm vs. 6.5mm of the include cable) to reach inside. See photo
- It came partially charged. When turning on the device the red light was on indicating a low charge (white > 3.8V, red < 3.6V)
After burning for a minute I charged it and it showed red for a second, then green indicating a medium charge. After 45 minutes it was white and off (= fully charged) after less than 3h total.
Too late to vape now. Just heating up to 220°. It remembers the last temperature. Blinks 14 times and buzzzz, it is there. Took around 30 seconds
You press 4 times to turn on / off, twice to increase the temperature. When on 220°, pressing twice goes back to 160° (buy why does this take time???)
From the manual:
Each bowl heating duration will last 3 minutes, after that, the device will go into a sleep mode for another 5 minutes,and the ceramic oven will stop heating. In the sleep period, press the power button down for 2 seconds to wake upthe device, and the ceramic oven will start re-heating back to the last temperature setting used.
Press the power button 4 times to turn off the device, the unit will vibrate once. Each cycle duration of 8 minutes (3 minutes of working + 5 minutes of sleep mode), after that, the device will automatically power off.