It doesn't work for wax or oils. Why would it work for anything else? I don't know anything about DMT. I just know the oil jars are absolutely worthless. Sorry I couldn't resist complaining.Would using the ascent oil jars work possibly? I never use that thing and need a reason to justify its existence.
I don't see any discussion about toads around here. It seems offtopic as there is no dmt in toads or your post contents.Where are these toads located?
I mentioned the Toads briefly a little while back.. Maybe that's why it was mentioned recently.. I think its on the previous page towards the end......I don't see any discussion about toads around here. It seems offtopic as there is no dmt in toads or your post contents.
That is a favourite method for many, especially because it delivers well at low price. But I prefer desktops as you can pull on them slower or faster and still get it extracted with no burning. When the effect is setting in it's ofter hard to even determine if you are breathing in or out, the two just mix up and start feeling somewaht simultaneous or merged, so controlling the speed of your pull at the end could get very tricky.vapor genie is the way to go.
I've never experienced any tolerance with this. Well, it's difficult to test as it's not addictive. But small doses can often make you want to repeat with more....but what I used to do was start a session with maybe 10 mgs, do it, wait a half hour, load up 15 mgs, hit it, wait another 30 minutes, go for 20 mgs, wait another 30 minutes and go for 25. For me, after 20-30 minutes, tolerance is gone.
Because of this, it works well to put in in a VapeXnail, or vape it as enhanced leaf (or in a concentrate mesh)....that stuff likes to run away from heat like crazy, even can defy gravity...
Me and many other experience mostly opposite effect. Not wanting to sleep and feeling refreshed after the trip. Just like after you wake up from a good sleep.I found it makes a great insomnia medicine as well, once it wears off, and a few times I have dozed off before coming back to baseline.
Makes me wonder how well their maude dib concentrate box might work for this.I once vaped some in the MFLB.
I was using it with some ground herb earlier, and it combusted which left the screen a bit scorched, so I decided it a good time to try DMT in it, simply by placing some extract straight in.
I only had a tiny amount left, what I would deem less than a trip but a comfortable amount, I doubt I would do that much so willingly now though.
It worked well, almost as soon as I applied power it liquidised and I immediately started dragging. Was a bit hot with only an acrylic mouth piece, left a strange sensation on my tongue but was soon distracted by the immediate although extremely mild effect given.
Works well, would recommend if you could afford a separate box or don't use yours often. The smell will last in it forever I imagine, I would not recommend using any vape set up used for herb to vape DMT. The smell is insanely sticky and it will always linger.
I've always found the combustion taste to be very similar to the smell, a very plasticky, sweet and sharp flavour. Using the flight box it was definitely smoother (a far cry from a spun cone, more inline with changa through a pipe but less harsh again), but that flavour is intense - you can't overwhelm it by toning down the temp, not enough to worry about.I think both MFLB and Maud dib would be terrible for it.
Too hot for it - it would combust and that tastes absolutely horrible.
Also I think it would be impossinle to get the smell of dmt or even worse - its combustion - out of the wood once used.