[QUO
TE="LabPong, post: 1253830, member: 34243"]Biohacker....I use a clone can matrix....here is how I got around the fitment issue with these types of water units.
First off, you can just go this route for the easy fix....
WIDE SIDE DROP TYPE
There are some drops that have a real wide gap at the top...but normally they are made with way too small thin glass tube sections. I broke a couple way too easy. So keep that in mind if you choose those.
I got one and use it on wider topped units. I would like to have it actually drop down....but it works to fit and moves it away from your face anyway.
I just add another 18 to 14 adapter and then the drop downs to give enough room to fit.
Then I did some minor glass cutting and used a much narrower 18mm downstem inside the main downstem. I always wanted to make the intake a much smaller condensed section that will give a bit more tighter draw/bubble. Now it hits so smooth and works better for my flowerpot and elev8r.
And it clears the main section by more than enough. Other dropdowns I have come closer but still fit.
And then my final tweak that made this piece work unbelievable (it always does though)......
A CARB HOLE This hole position is awesome. Makes cleaning easier too as it drains faster and such.
And I really like the real drop DOWN's that Thickassglass sells. But they do not have enough gap to fit the wider topped water units without a lift from an adapter....but the joint is super close to the main body.
[/QUOTE]
VERY NICE!
If your challenged FINANCIALLY $$$ a cheap low priced bubbler will get it done!
$19.93 & it work's?