Brilliant Cut Grinder

[Morty]

Unfortunately mine won’t stay in place. Always stays attached to the bottom chamber every time I take it off.

Gonna switch to a cheap S&B 2 piece in the meantime. Looks like bits of that dried glue could flake off in to the bud.

 

[.d]

Unfortunately mine won’t stay in place. Always stays attached to the bottom chamber every time I take it off.


Gonna switch to a cheap S&B 2 piece in the meantime. Looks like bits of that dried glue could flake off in to the bud.

Maybe contact BCG customer service if you are worried

 

[Bakin4Life]

Unfortunately mine won’t stay in place. Always stays attached to the bottom chamber every time I take it off.

Guessing that it will need to be re-secured not just from the bottom, but around the circumference, as well. Otherwise, it'll continue to pull out after use.

Wondering if an epoxy (e.g.; JB Weld) would be effective (and non-toxic, of course). Ensure that it doesn't bleed out of the top edge, when reassembling.

IIRC, the original JB Weld is gas / oil resistant. Which might bode well for isopropyl, as well (if you continue to soak, but I wouldn't, personally--a simple wipe down should be sufficient, IMO.)

Just a quick thought. Do your research before using, of course.