Search results

FYI, 'Our very own' CentiZen ships from Canada but charges in US dollars. There is no savings there. It's also misleading as there's no indication of this sneakiness until you get to payment.

Yeah, here's new bowl fitted with 0.25mm grind off aluminum brackets. Crack @12 o'clock, Fits Perfectly now, wish I ordered 2

Got a replacement copper bowl with tubes attached from @Mojo for a worn walnut basic. Tried fitting it to Vapman body, but last of 3 tubes to attach was always too short for my scorched & cracked Vapman body. Then it dawned upon me, Theory is that the walnut body had slightly stretched with...

Try holding the Vapman between middle finger & thumb. Awkward at first but lets index finger plug a hole to change draw.

Working outlet temp is 100-125 Celsius. Pulling hard on spent stems increases temps & risks gum problems.

Don't know?? Container lists 10 x 200mg tablets, TurtleNeck!

Dollar Store or Dollarama had them in Canada. 2$ for the 10 tablet container

The 60mm MP stem fits into Advil bottle once nipple on inside of cap is flattened. Smellproof, Stealthy & tough as Fuck

Yeah, just got some screens shipped to Canada from @Mojo too! Took about a week to arrive, tho @Mojo ships same day.

No, there's leakage thru charge port & under rocker switch, tho they can be blocked with sleeve offset 90 degrees.

@vapman, @Mojo, One of the three inlet tubes has come off the crucible. Can I reset it with a centre punch or anything else I can do besides sending it back for repair? Could you share a pic of your flaring/setting tool?

Yeah, Vapman can cure VAS too!

Water tools & long stems are fun, but the original mouthpiece, even POM, is most practically suited to Vapman.

Sorry OF, just talking about the heater/coil's average temp here. Like the element in your stove, its average temp drops if you keep the door closed.

Yeah, everything gets hotter with sleeve except average temps of heater & some parts of oven. The coil/heater runs lighter duty, thus lower average temps. This is the sleeve temp paradox

Yeah, while the sleeve insulates & increases temps in some areas, it also reduces the load/duty cycle of heater, which lowers the average temps of heater and some parts of oven. It's neither good or bad, just depends if you lean more on conduction vs. convection

It's easier to get pins aligned if the filter screen is free to move a touch on wooden section. But yeah, would need a jig, or a lot of luck, to get pins right with tight fitting screen.

1/16" SS 308 tig welding wire. Had to buy a pound, so have enough for a thousand stems. PM me, I'll send you some…

Nice stem! I use one long pin, straight thru. Drilled the pin's hole first, then if it's off or crooked, could use those holes instead to mount filter screen. Never turned wood before, already learned a lot.

Vortex Vapman from Walnut branch,