Search results

This isn't exactly new news - see http://www.e-cigarette-forum.com/forum/modding-forum/211964-alright-e-power-mod-7.html where an AW 14500 puts out .4 to .67 volts more than the stock 14650 in an ePower mod (nearly identical to an Omi V2.x). The measurements are for 2.0 and 3.0 Ohm ecig attys...

Rohm makes some extremely low resistance FET switches - These could probably reduce the drop, but I'm afraid it isn't possible to get a FET switch to have as low a drop-out as a mechanical one, in a typical configuration (now, if G wasn't afraid of inductors and boost/buck converters we could...

THC, your replacement offer is super-generous - Everything _I_ could want, plus the logo will match too. I really hope this makes everyone happy. I can't imagine any better support than what you have promised. Regarding the timeout issue - There is a simple answer that you can "steal" from...

What do we know about the re-boot problem? We know it is due to the end-caps, the change in V2 tube length and bad engineering. We know that early V2's (call them V2.0) came with protected batteries and a longer tube than current V2's (call them V2.1). I believe the tube was shortened in...

Actually the 5-click feature is from the ecig world. Joyetech added 5-click on-off to the eGo-T line a while ago, Yes there is a microprocessor, but calling it a computer is a bit over the top. BTW. The newest version of the Joyetech controller electronics (yes, you can buy the chip/circuit...

Not a joke. After 4 decades of designing and building military gear, the cases of failure must always be at the forefront. With a device designed to supply large amounts of power to a heat source, it would seem that safety features like "turning OFF" **reliably** would be an obvious...

It sounds as if the HVD may have been designed by the same person who gave us the "8" prototype that turns itself on? -NDA

I DO NOT WANT any Reactor/pass-through - I DO NOT WANT a Hammer. These are very lame excuses for changing the switch behavior. The only thing that seems reasonable to me is for D9/Warp9 to send everyone new/extra short caps - since the site DID say the end cap would work on both tubes. AND...