Search results

I have the newest heater and never felt the need of a vvps. I can dial perfectly my unit for any use with the stock dimmer, from whispy clouds to instant combustion. I do have lab grade vvps and a lot of nerdy stuff but can´t see a reason to use them in a Woodscents unit. My only complaint...

I have the latest WS model and it can combust even at 9, I use it from 7.5 to 8.5. About the Enano, I like the Woodscents flavour and density of vapor much more, and the vapor is much smoother in my opinion but the Enano has better airflow and more herb capacity so if you want to take huge...

I have the exact same thoughts @FlyingLow. Other users have reported no air leak so hopefully is some QC issue in our units. We need to find a silicone band of the right size!. I have also stopped using my Ace because of this. Using average quality herbs the difference is much more noticeable...

Rosin is smoother with the right temperature but flower can be almost as smooth with the correct setup (a flowerpot and water filtration for example) and it gives a full spectrum. For me the effects of flower are greater than the effects of rosin.

Yes i didnt explain well xD I change the water everyday! I use reverse osmosis water and it gets bad taste very quickly. Otherwise I dont clean my glass daily. I am the only one using it so I clean it when taste is affected. First I scrape everything from the condenser and then I clean with...

I use bongs with a very thin layer of water at the bottom, to add moisture. Not enough to cover any of the percolator tubes. It gives smooth vapor without losing taste and I can use the piece for weeks before It needs a clean. And when I clean, I usually scrape the oil and revape it. The best of...

Can we do one sheet with one of each? Why decide if you can have all xD

Hello @atragantrao I know you from Vaporizando if you need anything ask me PM and I will help you. Also, we can talk privately about some vapes I dont use anymore..

So @PPN and @Andreaerdna as I understand the issue I have with airpath is just my unit?

I don´t find it annoying just barely noticeable. My old Arizer Solo had a constant electronic buzz that drove me crazy and made me sell it but this one is like a faint beep beep. Just wanted to make sure it is not an issue. I think the magnets are strong enough and stronger magnets won´t...

Hello gentlemen! I have used the Ace intensively for a few days and it has delivered good clouds and zero manteinance without clogging or reducing clouds (15-20 loads from 185 to 235ºC usually). But there are 2 things that i would like to discuss with you: 1- There is a very faint noise, like...

I came to say that xD @justcametomind your problems might be inhaling too fast with the flowerpot. With micro loads breathe control is needed but if you do it right you will get much better results than using the Volcano, and using lower temps so no scorching flavour!

Burnoffs must be at max temp! I did like 10 of them at boost mode in order to cure the silicone and dissipate the plastic and electronics smell. Still I could smell a faint aftertaste when the unit was empty but after loading it with herbs for the first time that smell dissipated almost...

Get a little bong for your E-nano and up those temps until you get milky one-hit extractions, start inhaling slow. Do the same with your Evo, I have a Flowerpot and a Woodscents and have tried Enano and Evo: They are very similar pairs once you get the hang of it. With a little inhaling...

Have both, decide for yourself and then sell one xD

@rnartian my best success so far has been to gently press the spring up while the chamber is loaded, i can compress the load in the upper side of the chamber. It greatly improves performance.

Used the Ace last night and I got high as fuck. If fully loaded and packed this device gives very nice clouds and strong effects. It takes a lot of herb but one load lasted me 2 hours of use inbetween matches while playing overwatch. I started at 190ºc with very good taste and went up to...

Update: The ACE logo on the sliding mechanism has already faded in my hand. I just touched it with clean hands and it dissapeared. Now I have a darkened slider and i cant clean it because im wiping it and still stays the same

Hello gentlemen! I just received my Ace unit. I haven´t used it yet, still doing burnoffs. Build quality seems pretty good for a medium range vape, the unit seems easy to clean and sturdy. Airpath is great! Fully isolated, I can even see through the airpath so that is a big yes for this unit...

I just received my shipping info! One Ace is coming to Spain and will be here by friday if i am lucky