Search results

You think? :D:D It's hard being this high-polar :science: I think it's because I do a lot of research, so I'm always balancing in new ideas and ways to do things. Sometimes it can be challenging to focus with all the inspiration! That was an earlier idea I had, I posted a picture somewhere...

It's likely from stirring after every hit, it can pulverize the brittle dried herb and get stuck in more easily. I always used the FP as more of a one hitter or so. I brush it out while holding it upside down to encourage any crumbs to fall out the way they came in instead of force them through...

I just brush them out after every load with a S&B brush, at that rate it never gets dirty. These desktop vapes are some of the lowest maintenance of any

Stellar! :rockon:

I can get a full length session (or longer) with just a half packed stem as well, it's why I wish I had a PVHES!!

it probably takes more time with concentrates to start boiling due to the surface tension and surface area differences between concentrates and flower. A more conductive concentrate sleeve would probably work a bit faster. Like stainless steel. But I’m sure the silicone one is convenient for...

But why are your pants off? 😂😂

Vapecups are cool but I find they don't really hold enough liquid to be very practical. That's why I taped a volcano bag to my garden hose. On demand running water is an absolute hydration game changer, I might even say end game.

I sometimes torch the floor for a second or three to warm it up just enough to melt the resin off a tool.

IME one can prefer some of the combustion /decomposition effects that occur when vaping flower, particularly at the higher end of the temp spectrum. Similar to when smokers try to switch to vaping and find it “missing something.”

Stunning setup!! :rockon:

InV1.7 + 7 hole air inlet featuring central pearl loading hole + Round bottom inspired by bubble caps for easy joining to glass bowls, no ground glass joint siezing/sticking together for faster chamber clearing. + Side exhaust to induce tangential vortices and remove the "nozzle" effect...

Here's an old uptemp vid from a few years ago using the controller to initiate the temperature ramp with no inserts.

if Quartz was fragile in comparison, people would still be breaking boro heaters constantly like the beginning of this thread. Same reason why we don't dab on boro glass nails anymore.

That's normal. The head has to lose some heat to warm the bowl, that's why it's called heat transfer.

@justcametomind does the VD get a lot of use at your vape headquarters?

Using sift by itself needs a pretty fine screen but I tend to find you can make use of the plants own cellulose fibers present in the dry sift to keep the oils wicked. This is one of those cases where you really don’t want the highest grade sift. Something middle of the road will give you all...

If you hover a q tip in the oven tube while at your set temp, without the vial inserted, will it brown from radiant heat without touching anything?

Seems kinda goofy to me, floor is super small so all the surface area is on the walls, like a wok.

How can you achieve 400 degree radiant heat with just a 430F set point? That seems extremely efficient, i have to run at 700-800F to produce radiant heat in the 400F range. I always said if Dry sift was more popular I would never grind again. You get the benefit of undisturbed trichomes, high...