Search results

sorry for the double post

Just received the Atomic recycler. It seems decent for $169 shipped but I have yet to put it to use.

Same here, if this turns out to be a game changer I will order one at some point.

I just pulled the trigger on this. I'll post some photos after I receive it.

Assuming that's true, given all of the issues, I'll certainly hold off on purchasing one for now, if not permanently.

I can't say I regret any past grav bong hits, they were always so much fun. A few keg stands I did regret later though =D

This has already been covered earlier in the thread. Yes but you'll need one of these as well since the PNP charger only has an AC adapter and not USB: http://www.amazon.com/gp/product/B003059FAI/ref=oh_details_o03_s00_i00?ie=UTF8&psc=1

Each pill holder has a plastic bottle inside. I used the metal cap from the inner plastic bottle.

http://www.amazon.com/gp/product/B002EZT9S8/ref=oh_details_o01_s00_i00?ie=UTF8&psc=1 Note that some of the pill holder outer caps are just a bit too large & you'll need to find another spacer other than the metal cap from the inner plastic tube for these ones if you'd like to use them to hold...

Yes I let it warm up, I prefer when the wood is nice & hot rather than waiting only a few minutes. I find that my temp setting varies depending on strain, grind, & moisture content of the material. It may be that I just need to bump the temp up a bit but in this case I feel I'd combust once I...

d I use the pill cases as well but I wouldn't mind picking up a bullet holder as well for carrying more than one or two bullets. It would be nice if there's an easy way to dump a hot bullet into the new bullet holder. On the pill cases I took the cap from the little bottle and shove it upside...

It's hard to put down the PD for good, it still runs strong.

PNWT worked nicely with a tightly packed nug & a setting of 7.

This might work for a few pulls before the nug starts to fall apart, but from past experience, holding the bowl upside-down places the material too close to the heater & it will combust easily (perhaps a lower temp setting will suffice in that case). When I use a nug in the gong I typically...

How do you plan on rigging it Ataxian? Orienting the bowl 'right-side up' will leave the WT upside down (see below photo). Perhaps packing the bowl nice & tight or rigging tubing between the WT & the gong will be in order.

Same here & I happened to be reading the forum when told to email re: the replacement pong so I know I'm one of the first to email Eric regarding this issue. Hopefully it will be addressed Monday.

PNP+WT on setting 3.

You have the thicker-walled PES Pong. If you scroll back a couple of pages & look at the photos Engineering posted, it's pretty obvious as there are 2 photos of PES & PC pongs side by side.

Mistakes happen. TRVB could easily have sent out replacement Pongs & made some lame excuse or told us nothing about the discovery. I personally am happy about the fast response time to looking into the issue & the full disclosure. On another note, I had my first session with the Pro last night...