Search results

That's what I was thinking, yes.

Flame the end to shrink it up some maybe?

These are two techs where the pa is a 3rd. I've never been comfortable being tangled in wires. Never liked ear buds either. Your solution is a natural evolution with today's tech. If someone points me to a solution for under a bill, that would motivate me. And no worries - I don't have...

I am liking the remote switch on my IH. It is a very light tough to depress. It is "mains power" meaning no parasitic drain. This particular switch is momentary so it is never left on accidentally anymore (this switch has a pull-on-bypass if needed). I hold the IH in one hand holding the...

:rolleyes: I have 3 standard chargers and they are all different as far as the pocket where the cell sits. Still some design work to do to complete that in the puck. But if you have a Ni-Mh charger what can take a standard sub-C, this thing is ready to go. And no, I'm not after your money...

That definitely counts @Choices . And definitely subscribing to the fresnel posts when they show up. Sun-source or LED source? You didn't answer the question though... Are you preferring a mod or cell solution? I can certainly forward the prototype 3800 if you want a taste of this thing...

We have a winner for the '19-M stem replacement. A light golden brown patina on a satin finish for style. Ends are shrink-fit - no adhesives and they are stuck!. :D

:whip: No DIY-genes @Choices ? Mods or cells?

Perhaps... but we learned to bake cakes too :clap: Just reach in every 5 minutes and give the vice another crank. That was the 'oven mitt' comment. I've done stranger things decarbin' :rockon:

Load it before loading it into the oven. That way everything rises in temp evenly.

Funny - people tell me I get everything I deserve :freak: ...and I earned every scar!

Any drawbacks in taste?

Do you tear apart mods to see what makes them tick?

Well now, I didn't see this coming :doh: $5.99 set of stainless steel straws, a tube cutter, a flame torch, a fresh quince branch, and a serious VC vape cooler is born :mental: We'll call it an OUTER-COOLER :goon: ...anyone got a problem with that? With this newly found natural...

Agreed. I see torching as a variable that could use some greater control. Then again, you could just place the whole outfit in an oven for preheating and use mits to press :science:

I've mastered ohms law some 4 decades ago. That is why I was wondering what the voltage peek was that the mod would put out. This is a case that can be real hard on internal components if not mitigated. This is due to to the energy in the chokes used for power conversion. Excessive spikes...

One can attenuate VAS in the DIY laboratory. Same VAS but much easier on the cash flow. Too retro? :rolleyes: 6mm OD stainless straw with Quince caps. Outer-Cooler! :tup:

I saw the 70W and I can assume 0.23 ohms still. But it would be interesting to know where the peek voltage went to. That will tell you something about that little glow in the earlier session. Essentially characterizing the response to feedback. That is one thing in these mods is that they are...

Certainly more integrated, indeed. I was considering rapid and sustained heating. Maybe even part of the barrel with a heat shield cemented with ceramic epoxy.

Nickel plating? Bad nickel plating? ...stogies have been gone for years. Nicotine is so yesterday :wave: welcome hemp! :p