Search results

Yours?

That may be your solution; step the voltage until it hits at the rate you want.

Nice work indeed @LesPlenty - true, these are cheap as dirt. And when they work, they just work wonders. And you are running 2x 18650's. Perfect! Have you tried the direct draw while heating yet?

Looking forward to what you come up with @scy123 :tup:

Your MOD doesn't tell the ohms when the cart's installed? ...welcome to the forum @Drewscot :tup:

The chamber heats insanely fast with a full charge. It is a really nicely thought out design for the class of vape this is.

500-1000 complete charge cycles is the normal life. There are caveats in that manufacturers have to say when your cell no longer performs 'optimally' and should be replaced. That could be 90% or 80% capacity. That means there are a lot of dregs left. Mostly Li-Po battery packs tend to...

I fly by magic carpet :rockon:

I am getting a little too deep into it but this is fun. I order a couple more switches from Digikey this morning. I got the 16A ones this time. Considering this unit is rated at 120W, I am not worrying about the power level. With a good solid 12V, the VC is a little smaller than the...

Anyone know what zener they use on the ZVS board? Alrighty-then; found my 2S 18650 pack. Plugged it into the DD-IH; 8.3v idle; 7.8v @ 1A; 6.5v @ 4.5A. That's say 30 watts. If you ever wanted control over your VapCap, this is it! ...if you don't drift off and forget to let go of the button...

Wait, people have bragged about how easy this thing draws. Maybe that was just stated wrong.

Absolutely. Ti v. SS is simply mass. Mass means heat load. SS has more 'heat capacity'. The caps are just a sensor to tell what the temp is. If you want to drop the temp some from your standard cap's performance, indeed, play with a low-temp cap.

Aha, finally some data to share. I didn't realize the Target Mini II could be used as a watts meter. I can now give an accurate [ha! best derived] consistent data on performance based on voltage. Source - a well used launch box reporting 0.08 ohms on the TMII. The Mini is set to variable volts...

I learned the same thing when I used a glass stem for a short time. A lot of keif stuck on the walls. Don't they make VC-sized dosing caps? Now that would awesome :rockon:

I only have my bone stock China IH to compare and at full power it is a hot IH; same as PSM and Caldren core design. By the time I sense the heat in direct-draw mode, it is too late; it's combusted. When I brought the power down, I could react in time to avoid combustion easily by modulating a...

The IH is dynamic and will use whatever power you give it as long as the gate circuit holds up. I like the way she just demonstrated my point on real-time IH heating while drawing. That Apollo wired to the power bank must be under-powered allowing for modulation. Or the Apollo is just a low...

Time is money, indeed! :tup:

$59 is a good clearance deal. Remember that DV was selling '18-M's for $20 last year. And if it turns out to be fake, take it back. I doubt it is though. '18 v. '19 is 3 notches at the rim of the bowl. '18 doesn't have them, '19 does.

And Norton complains about a Malicious Domain Request 22 on that first link.

Caps are shiny until they see the torch.