Search results

Cool! David

*********************** Redirect. *********************** 2.5 packed bowls fron one 18650. Out of batteries. David.

I will gladly make a steel sleeve to shrink on the copper. My IH will rock the anvil. Help me prove it! David

Taking the battery out of my Xmax so Herbie and I can enjoy the superbowl. ;) David

Wahoo!

I took Herbi to Boston. 3 day trip. Upon arrival, first attempt with Herbie. Kept getting "shorted coil" after futzing around, I made a new coil. A few adjustments and he was working fine. Herbie went on the Orange train to Downtown. It seems I can use it until it burns my lips...

If you look at the end, there is a loop of wire. What ever carbon steel part you put in it, turns red hot. Works great on exhaust manifold nuts. I paid double that for the same tool off the snap on truck. David

🙃 Remove the bread after an hour or two or overnight. David

I have an IH that will turn a 1/2" bolt red. 1,000 watts. All I need is an anvil. David

To add moisture, just add a small piece of bread with it on a sealed container. It doesn't take but a couple hours. David

I don't use it on a water piece. Draws hard. I cleaned both mouth pieces, then tried the unit alone. Draws hard. Did now when new. Almost un useable. David

Getting hard to draw through. I cleaned with ISO. It's the unit, not the mouthpiece. David

Today, I took a 16mm OD glass tube with a 12mm basket screen. pressed the glass end against the tapered part of the bowl. I put my hand around the holes in Herbie. I could easily hold it so there were NO air leaks. It just seems to fit. I have a silicone band that goes on the end of the...

2 flames in the back, one near the clicker. It's a good torch. David

Thank you VE and KeroZen. I set the TCR to 105 on my Ecvic. It seems to work fine. I did a LONG hard draw and it keeps up with me adding power. I keep reading "All mods are different" and just above me it says...

Thank you

Yes, I tried locking the resistance. I am still learning. David

Kinda quiet here..... A few notes. I tried a spiral coil. It seems its not too important. I have been trying to describe how to set the MOD. On my Evic Dual, I pull the top off. Look at the coil, press the button @ 390f. The coil should just barley glow in the dark. Turn it up to 450...

Aluminum had worn off my stainless grinder? David

Someone mentioned preheat. I set watts at 150% for first 2 seconds . Great, a real first hit. Now it's c ooking along. Good hits. Release and press. You have 150% again for 2 seconds. It's now a combustible fucker. Forget stealth IF it combusts. David My Evic has a 60 second...