Search results

Ha! Tis ironic. Wonder if the name is on the battery door cover :freak:

Only benefit imo is the ability to clean/soak with iso fully assembled. Just as easy to take apart though and I alternate stems after cleaning. Ya, anything a Dyna fits, this should too :tup:

Ugh. Mine did the same awhile ago. Plate cracked starting at the screw which I never messed with. Eventually broke in half and ditched it. Have a few small pieces of tape to hold now with the base off, but still slides a bit when refilling.. annoying :cuss:

Awesome! Bet that’s pretty comfortable. I have the same scrap end since I copied you on the ZX handle :ko: Threw mine on the 14 coil.

Yea like Yogi said, no prob. I did this combo in the TA and it worked just fine. The Sic really adds some extra heat. Fun for a bit, but went to rubies in that one which I’m liking. Thinking you’re heat up method (slow/fast) could be a variable in the performance of these as well :shrug:

Me too. It’s a bit of a chugger as the glass narrows at the perc entrance pretty good.

Any medium sized torch at your local tool box store, ~ $20-$35 should be fine.

Are you in the states? I have one from TAG that is nice. Use mine at the mouthpiece sometimes. https://www.thickassglass.com/products/degree-angle-adapter

A few shots of some accessories from DFreeZ Designs for the SB :rockon:Coil & bowl handle set - burl w/ blue resin and a micro diffuser bowl - cocobolo.

A foam insert in a small box my ecig kit came with. It just happened to wedge in there pretty good. A little shaky with the vape on it!

For sure! Had a good dry run earlier with THIS TRWW setup :tup: Easier for me though to get a full extraction using water and some restriction since it’s pretty open. My thinner heater ramps up fast, and also cools fast. Sometimes needs another twirl with the flame to keep it going, other times...

Neither of my stems need much cleaning at all. The only place on the inner lining that collects resin is where the bowl meets the spiral insert, and not much! Easy iso swab on either the Ti or Wood. I soak/shake the other parts ;)

Couple of sativa dominant strains picked up today with a nice discount :brow:

Finally got around to putting some much needed bomb ass butter on this quick-draw-McGraw manual :cool:

Was just using the boro for about a week. They get HOT like the sic, but without that distinct taste I get w/sic. Was RTL on the normal 2nd VI mark so had to tone it down. Cleaned up my scorched up zircs and threw them back in .. my preference for this vape:tup:

@AndyO I get that, especially with your loc. Betting if you email him you could cancel the order but have to wait :\

Is the bowl surrounded by the coil alongside the cap in any of these IHs? Want max conduction .. pre-heat bowl with a far away flame, load herb carefully, strap on cap, heat with preferred method :brow::lol:

Oh snap. Yea I was sizing it over the bowl body without an adapter on it :doh: Doesn’t even mount there. Same sized ring & handle then. Thx for pointing out :tup:

I think they are different. Just took my ring off the heater and it’s way too big for the Vulcan. So I typically do a couple of bowls, with a couple of pulls each time, fairly low temp. If you’re doing more bowls, longer seshes, and running hotter .. might be worth it to get the ring & handle.

Pretty much ;) Made notes in your post.