Search results

maybe your button failed. try shorting the posts together

that is top tier congrats

mighty screens work great for this. they’re sold on amazon as ‘15mm screen’ it’s like a 200 pack for $9

joint packing works great for WPA though

Right before the vape mail ban, I put in a big order for mods and parts, and they never shipped. Finally they got the shipping logistics worked out and were able to send it to me. I recently got stuff unpacked and set up, back into the old designs and reworking somethings to at least make and...

snacks is dead on, the US custom resistance trends closer to .4 or slightly under i think and the chinese ones float around .44. I do like my wattage around 55 though because it will go to temp and ready to hit in like 3 seconds. I feel like more power up front is more battery efficient too...

ive never taken one apart on purpose, and you may want to try it on a donor mod, but if you get the splinter body really warm and try to overtighten it on the 510 connector, the glue holding the RDA base on the bottom will fail at some point and the 2 pieces will separate. that said, i dont...

there’s more not pictured lol… my gf helped me wax them last night. > why do you have 7 of the same thing? because i sold 6 of them already? > *blank stare* ok besides they’re not the same thing. this ones a v1. this ones a v2. this one is US. this one is chinese… > *blank stare* fine, i’ll...

i thought that too. have you checked them lately? depending where you live the weather has been much more extreme :/ seen 30 degree swings several times, thats probably what did it edit: I totally spaced on pic -

found a recipe online and my gf made some for me. there’s a lot of pretty similar recipes for it floating around (wood butter). pretty happy with it so far. consistency is a bit goopy, waiting to see if it thickens up anymore

man, PSA to butter and moisturize your vapes. i went through and did a bunch of mine last night. they look way better and a handful had new/worse cracking than before :/ i should’ve done that much sooner

i’ve been doing small bundles and putting them on entexchange but i haven’t been able to do as much as I wanted. i think the amount of design and changes to make them properly functional would be too much vs some other projects. - the threading alignment varies mid to mod on their 510...

It's been a year of obsessing but I finally got things together to make some heaters and possibly some DIY kits. one of the worst tricks played on the community was the dead-in-the-water open source initiative and empty promises of putting kits together for people.

> splinter acting erratic PSA - make sure the screw on the 510 connector is tight

Hmm well i don’t have any zions or canarywood Z.

pretty standard, the heater inside will typically lean to one side. hotspotting in general, seems to happen to all pure convection vapes. you can kinda mitigate it by playing with technique - sometimes a lower temp with a slower inhale will heat things more evenly. i just resign myself to either...

it’s not coming out probably. the screen is friction fit in there and if it comes out you’re gonna have a bad time. air compressor? ‘keyboard brush kit’ might help. pretty much all used RBT devices have crumbs down in there, just inevitable

if its unregulated why have an RDA in there?

got a rubber stopper from home depot, 1/2in (x 5/16) seems to fit the carb hole pretty well

Things are on hold right now as i get set up in a new location and modify designs to work with new parts