someTooL's latest activity

Nice! Mine should land here in SoCal tomorrow afternoon. Ended up grabbing a 4ah M12 battery/charger combo at Home Depot so I’ll be...

Any truth that there are 2 Puffco Easter Eggs 1. that raises the Pivot's high temp to 600 and 2. lowers the low temp to mid 400's. ...

Happy Sunday!:science::razz:

Dovetail “At Home” stem. XL “Out and About” stem and XL Anvil case for reference. Comes in ~ 9inches. Very nice, very recommended...

I use cascade mode not for back to back bowls, but back to back reheats during same bowl.

Definitely has power calibrated differently. John mentioned that in his Instagram post when he said "we redid the coil output...

My pin is out the bottom about 1/8”. I use my Anvil more than the Tornado and I can barely remember to change the Forge settings...

Glad you tried the lower settings and enjoyed. My pin is almost flush with the bottom plate. I’ve found lowering the pin will produce...

As another Cascade mode Aficionado I of course had to try these settings vs my usual 5500/85% setting. I do the cold start hit and two...

This is for v2, right?

4200 at 95% has been my sweet spot with Cascade mode. 1 click, then after 2nd heating 2nd click. Usually pull 3-4 DEEP hits this...

You could try messing with your draw strength, and/or airflow settings if you have any. How tightly it's packed is another critical...

I think we agree they're both powerful. If portability is a big desire then a desktop IH isn't the best answer for you. If you're...

I highly recommend looking at @Aezhenn's work as he does some impressive wooden and glass stems. I like my setup because the draft is...

Just make sure it really has reverse polarity protection before trying the battery reversal though, otherwise the magic smoke might...