Recent content by Delta3DStudios

Australia Vaporizers was my authorized retailer a while back, but I haven't heard from them lately, and it looks like they're out of stock on most devices - so I dunno what happened to them. Never heard anything (I never do - they just never order again)

How long are you pre-heating the trigger before you start your draw?

Haha yeah - I was surprised to see an order come through so fast on the new listing. I promise your order will ship soon - I've been getting slammed with more work than I anticipated recently That's awesome! Thanks for the link! So it's the Hyperdyn Dosing Capsules eh? Shame they're out of...

Has anyone found another brand dosing capsule size which fits the FATx oven? I love using dosing capsules for a variety of reasons (prefilling them with one of my loading trays for easy refilling, keeps the oven cleaner, more uniform extraction, etc) but don't know what size fits or how they'll...

Gotcha, that makes more sense - yeah I'll revise the design with those dimensions for that size o-ring and finalize the design. I am only going to order one copy printed in stainless steel to start and if it fits, I'll get more to add to the shop (technically I'm going to start by printing...

Yes I can try to add one more o-ring in there. I was going off the O-ring dimension you provided for the 9mm side.... I need you to measure that o-ring for me so I can match it. I believe you measured and said it's 8mm which makes no sense because it would be a loose fit if it is trying to...

Any feedback on the 9mm male side? With an 8mm oRing we're off by 1mm..... so I'm afraid it will be a loose fit

I promised I'd whip up a rough draft this weekend ;) Here's what I have compiled so far This adapter has an 8mm female opening (straight round opening, One centimeter deep. I've added some details such as cooling fin notches on the sides to help dissipate heat (because this steel will...

So on the 9mm side? I can try but I might need to make the connector side longer than 10mm - I'll see how it looks when I'm finished this weekend ;)

Hey all! Spring’s in the air! If only I had time for some shop spring cleaning!! 😩 Few updates since my last big post..... Jyarz Containers Are Back - I don't believe I mentioned it here, after nearly a year, @JyARz containers are back in stock! Right now I’ve got blue and orange Satchmos...

Ok cool, I'll make both ends 10mm, with two o-rings on the one side, I should have time this weekend to finish that - maybe I'll share a teaser of the rendering here to get y'all excited :-)

Awesome, so y'all want it to work with o-rings which have an 8mm OD (7mm nominal) 1mm thickness. Totally doable. Do you want something with some cool design (like heat dissipating fins) notched into the side of the middle section, or knurl finish for that added cool factor? I can add...

This sounds very doable, but I would need to know what size o-rings you intend to use (thickness + inside diameter) so I can model them in the software). If I'm gathering this correctly - you need a female which is 8mm Inside Diameter, and then on the bottom you need a 9-mm male joint, with...

I have no doubt I can help make what you need, but I'm having a hard time trying to picture what you need. Can you (or someone) send me a draft a rough sketch of what you need? Preferably with measurements so I know what dimensions I'm working with. I'd likely make the part using surgical grade...

I've been lazy lol - I've been doing high temp dry hits to clean the screen as opposed to replacing it yet. But yeah I should start with that. However I notice the ceramic part itself where the stem connects seems pretty 'sticky' already - so I bet there's some honey buildup on that part as...