Recent content by Coreshot

Are there any basket screens where only the bottom is mesh?

Love all the replies. Dynavap is pretty perfect except trying to torch in the wind and sunlight. I think I lean most towards something like the potv one so I can have dosing caps and if I destroy it wasn't that expensive. I will have to check out the Fog pro though as I'm not familiar that vape...

I have a crafty+ but I still don't find this to be great for the ski lift. Heat up time is almost 2 minutes out in the cold and I don't wanna fall on it an break it during runs. Any suggestions?

I've been trying to adjust it because it's way nicer than the generic ones and being smaller the HLT is easier to rotate on the WPA.

I tried one of these and it's a little bit too small for the hlt. It slides up all the way to the screen and flower ends up stuck to the screen. I also tired filling just with the built-in glass screen and I had to turn the temp way up, also tons of flower fell out the bottom when I stirred.

Scored one! Gonna be my first desktop.

I found that storz & bickel dosing caps fit very well in place of the screen found in the bottom of the bowl.

I take my dynavap with a hotshot IH in the cup holder.

I have tried it with a jhook that was decent. Hydrotube might be the way to go. Thanks.

I just got my Dotleaf today and my first 2 sessions have been great. I also have a Crafty+ ( better flavor) but the Dotleaf gives a very satisfying hit in a great form factor. The vapor is a bit harsh on temp 3&4, are there any glass nipple stems that will fit? I haven't seen any 510 drip tips...