Recent content by Chippl

Honestly, a super unhelpful advice. 1. If device could "melt from the inside" by just burning it off then it's a bad (and dangerous) design in the first place. There are easy ways to mitigate that, for example using additional temperature sensor as a protection. Not to mention quality materials...

Sorry for late response, last week was a bit hectic for me. I do agree it's not typical for your devices. I owned HR Fury Edge V2, tried SE, and vaped multiple times through my friend’s Rogue. I also always appreciated direct and prompt communication here – even though I mostly read the forum...

I appreciate the reply but honestly don't quite understand why'd I contact you via e-mail. Why not let others know how to deal with the smell? I went through the comments in this thread and I can see that I'm not the only one. Honestly speaking, I even saw those comments before buying the vape...

I was really excited about Fury 3 coming out, I loved my RiP Fury Edge V2 so much. However, I need to return my V3 unit. After multiple burn-offs it still gives robot farts. No herbs, no nothing, just really long burn-offs (with and without mouthpiece on) and wiping down everything with...

That'd be great! Initially I was hoping to see it coming out this winter, but spring sounds good enough ;)

Got it, I appreciate the prompt reply. Is there any estimated R&D time for Fury 3 once HR Team will start working on it? I owned Fury Edge V2 in the past and absolutely loved it. Unfortunately it started to malfunction (button problem) and was replaced by my shop for Fury Edge SE which I didn't...

Hey Healthy Rips team! Can we expect Fury Edge update anytime soon (like we did for Rogue)?

Yeah, especially when you're vaping those electronics ;D If the temperature was the case here, then this in anything but a proof that there's a bad insulation inside this device, which should be quite scary.

Wow, that's a concrete explanation and quite specific knowledge :) Thanks a bunch man! Just out of curiosity. How do you know how TM units are calibrated? ;)

Are you sure about that? Did you see how the coil is screwed onto the board? There are just two connection points to the coil. One though the single point on the main board. One leading to the battery though the steel(?) tape going up to the top cover – top case serves as a conductor to the...

You may be right, I am not so familiar with e-cigs etc. :) However... In fact (if I'm not wrong) the current flows directly from the battery, through the top case, then through the heater, down to the electronics board. I'm no expert in electronics, but having seen the internals, this is more or...

While I'm not 100%, I'm pretty convinced that's how it works. That's it :) I did not read the whole conversation here, although I think that you might still call this vape a regulated one. I also believe that once the dial is set to some number and heater will reach this setting's equivalent...

I believe that in fact you are not setting the temperature (per se) by turning the potentiometer. You are rather setting the power that will be delivered to the heater.

Sorry for late reply and thanks for trying to help! :) Please don't take me wrong. I didn't mean to be too harsh, however I was pretty disappointed when I received it. I got it from the shop as a replacement because one of my FE's button was not working properly. I am not sure if they will...

I would strongly advice you to do so, my guy! I just received my parcel from them and I need to say that they have some outstanding quality of service! :) They are so helpful, and so fast with it, that it's almost unbelievable for me. It took me literally less then a week (around 5-6 days) from...