• We are experiencing temporary outages. Keep trying, it does recover. We hope to rectify this as soon as possible.

Induction Heater Yllvape IH Power and temperature controlled induction for use with Dynavap

This Is My Vapestick

Active Member
great, I went ahead and pulled the trigger on the 3.0, I also have the 2.0
I am still waiting on my Simrell Engine to arrive, USPS has been pretty bad being on time, in fact they have been very, very bad, lately
its been over 2 weeks, never used to take this long
For the 2.0, I completely removed the ceramic insert plug to get it to fit in deep enough, although I would prefer it went in just 1-2mm more. So far I've got pretty good results with 45W for 45seconds. I have a Wand, but use the yll 2.0 for the Simrell if I'm also using the Tempest at the same time so I don't have to change around adapters/inserts on the fly. Otherwise I use just the Wand with the Simrell. You'll love his engine - it's incredible. It feels so calculated with incredibly precise engineering, like an Italian sports car. The experience is well worth the wait.
 
This Is My Vapestick,
  • Like
Reactions: HumbleLivings

HumbleLivings

Well-Known Member
For the 2.0, I completely removed the ceramic insert plug to get it to fit in deep enough, although I would prefer it went in just 1-2mm more. So far I've got pretty good results with 45W for 45seconds. I have a Wand, but use the yll 2.0 for the Simrell if I'm also using the Tempest at the same time so I don't have to change around adapters/inserts on the fly. Otherwise I use just the Wand with the Simrell. You'll love his engine - it's incredible. It feels so calculated with incredibly precise engineering, like an Italian sports car. The experience is well worth the wait.
hey great feedback, I have noted all this to test it out once my Sim Engine comes in,
thanks for taking the time so share your feedback :tup:
 

HumbleLivings

Well-Known Member
Forgot mention, the 45W/45s is a good starting point. I typically always use higher wattage or time than that and I almost always go ~5 seconds past the click for a decent medium roast.
I just got the Sim Engine,
tried Yll IH 2.0 took off ceramic, tried on Boost Mode 60 seconds (but pulled it off at 14 seconds left) did not go the entire 60
had a good session with that setting, then i cooled Sim down with Sim Stand which works great to cool it down

loaded again and went same way except this time I waited till it got down to 10 secs instead of 14
seemed a bit more hot, I think I may have combusted except i was doing small littel draw hits,
if i had gone long I might have combusted

what are your settings with YLL IH 2.0
with higher wattage than 45 watts?


do you use Sim Engine with Wand?
if so what settings do you use
 
HumbleLivings,

HumbleLivings

Well-Known Member
so far the best setting for Yll IH 2.0 wSimrell Engine on wpa
has been:
60 Watt
50 Sec

i tried 60w at 45 seconds
its a noticalbe difference with just 5 seconds more on 60watts
which is best setting for my liking so far ( 60W/50sec )
 
HumbleLivings,
Top Bottom