Help VapCap M Please

Ricd

Member
hi guys

Just receive my vapcap M yesterday.

I tried to use, but didnt make any clouds. I feel the taste but nothing more.

I respect the click, im using a triple torch from dynavap, and i heat a little far from the M for the matterial inside heat better.

Can anyone help me please!?

I just smoke Hash, and i bought this one because everyone said its amazing.

So what am i doing wrong?

Sorry about my english

Many thanks

Ricd
Portugal
 
Ricd,

howie105

Well-Known Member
hi guys

Just receive my vapcap M yesterday.

I tried to use, but didnt make any clouds. I feel the taste but nothing more.

I respect the click, im using a triple torch from dynavap, and i heat a little far from the M for the matterial inside heat better.

Can anyone help me please!?

I just smoke Hash, and i bought this one because everyone said its amazing.

So what am i doing wrong?

Sorry about my english

Many thanks

Ricd
Portugal

A few questions for you. Are you getting good air flow when you use the vape and what colour changes are you seeing in your hash after use?

Don't worry about your english, it will all work out and welcome to the board.
 

Ricd

Member
A few questions for you. Are you getting good air flow when you use the vape and what colour changes are you seeing in your hash after use?

Thanks for the answer.

The M have a good air flow, and my hash just get a little bit more darker, but just a bit, almost nothing.

Already put a big piece of hash inside, and a small piece but is the same. No clouds. Have some malleable hash and hard hash but both didnt work :-(

I have a firefly2, and i take more and less 3 days to know how to do clouds on that. But the M seens very easy to use. To be honest dont now what to do.

Single flame our hemp fiber will help guys?

Thanks

Ricd
Portugal
 
Last edited by a moderator:
Ricd,

Squiby

Well-Known Member
The Vapcap is fantastic with hash. I vape both hard Moroccan hash and soft pliable Afghani hash. The trick for me is to create lots of surface area without crumbling the hash.

For hard hash I slice the hash very thin using a razor blade and pop it directly into the Vapcap chamber. No hemp fiber or anything else.

For soft hash I pinch off a bit and flatten it between my fingers to form a thin pancake. Again I just pop it into the herb chamber as is.

I like to heat the Vapcap cap over it's bottom half (this is the end of the cap where the digger outter is attached) a good second or so past the click. The air intake hole located on the body should be covered with your finger as you pull vapor into your mouth. Do not pull the vapor directly into your lungs. Once you have pulled vapor into you mouth, you move your finger to allow cool fresh air in while you continue to pull and inhale the fresh air along with the mouth vapor.

Hash takes a higher temp to vape nicely and produce clouds. So heating the bottom area of the cap and heating slightly longer coupled with mouth pulling should bring you the results you seek. Good luck!
 

Whissmu

Well-Known Member
It needs more heat!
As you have already been told by several members of FC .. provide more heat, when you hear click start counting 1second, 2s and test if the results are scarce increase the heat 1s, 2s, 3s and try ... so until you hit the bullseye !
good luck!!
 

Krazy

Well-Known Member
I smoked nothing but hash back in the day (not with a VapeCap).

As others have mentioned surface area and more heat will do the trick. Iv used hash a few times in both my Omni and my M simply to try it out. I heat past the click and make sure to rotate and heat the entire cap. I use a water filtration device; otherwise, be careful of hot vapor on your lungs.

For non-hash concentrates? Someone recently mentioned this in the main VapeCap thread. http://fuckcombustion.com/threads/best-of-dynavap-vapcap.24345/#post-1145395
 
Last edited:

Ricd

Member
I guys

I just heat more 2/3 sec after the click, and put the lighter more close to the M and now I have big clouds like you all said :-D

I want to thank everyone for the help and advices.

It's an awesome piece, when my friends saw me smoking on the M got very impressed.

Many thanks

Ricd
Portugal
 

Whissmu

Well-Known Member
I guys

I just heat more 2/3 sec after the click, and put the lighter more close to the M and now I have big clouds like you all said :-D

I want to thank everyone for the help and advices.

It's an awesome piece, when my friends saw me smoking on the M got very impressed.

Many thanks

Ricd
Portugal

Happy clouds friend !! :tup:

Remember if you use green flowers --> respect the click !!!

..for everything else...
.... mastercard !! Jis! jis! :rofl::rofl::rofl:
 

tashian

Well-Known Member
Thanks for the answer.

The M have a good air flow, and my hash just get a little bit more darker, but just a bit, almost nothing.

Already put a big piece of hash inside, and a small piece but is the same. No clouds. Have some malleable hash and hard hash but both didnt work :-(

I have a firefly2, and i take more and less 3 days to know how to do clouds on that. But the M seens very easy to use. To be honest dont now what to do.

Single flame our hemp fiber will help guys?

Thanks

Ricd
Portugal


Hi

What about the FF2 with hash? Is it worth it?
I use the Vapcap but would need something without lighter when on the move.
 
tashian,

Elfgrin

Well-Known Member
Hi

What about the FF2 with hash? Is it worth it?
I use the Vapcap but would need something without lighter when on the move.
The chamber gets quite hot on the concentrates setting, though I've never tried hash in it I've put quite a bit through other vapes and I'm sure it'd be more than capable, especially with the surface area increasing techniques described above.
 
Elfgrin,

Ricd

Member
Hi guys

Yes @peabreu

The FF2 is amazing, the taste is great, but to smoke on the move, im not sure if the best vap for u. Because when we are smoking you have to pull the smoke from the vap betwen 10sec/15sec.. and is a bit hard on the firsts 50 times, and the baterry is a nightmare.

But excluding that is a very good vap.

Sorry about the late answer, and my english

Thanks
 
Ricd,

Kroisbc

New Member
I'm a beginner with all this stuff.
I accidentally combusted (i think, because a smoke puff came out from the Vapcap) hash with my Vapcap.
Is it "safe" for me to inhale smoke from combustion? Or should i throw away the combusted hash?
It only combusted a little so i'm sure it still has plenty of THC left in it. So smoke it or throw it?
I would appreciate a fast reply.

A vaporizer doesn't have a filter which filter out the worst stuff from the smoke. Pipes and joints etc. have a filter i think
 
Kroisbc,

MinnBobber

Well-Known Member
I accidentally combusted (i think, because a smoke puff came out from the Vapcap) hash with my Vapcap.
Is it "safe" for me to inhale smoke from combustion? Or should i throw away the combusted hash?
It only combusted a little so i'm sure it still has plenty of THC left in it. So smoke it or throw it?
I would appreciate a fast reply.
.................................................................

IMO, there is no sense in wasting good hash, if you partially combusted. I'd empty and inspect, and then load back in / squish with fingers to form a lot of surface area. Is there a black edge on it (combusted)?
Then heat again but be conservative, a second past the click, and try again.
You should be fine.
Vape on
 
MinnBobber,

Kroisbc

New Member
.................................................................

IMO, there is no sense in wasting good hash, if you partially combusted. I'd empty and inspect, and then load back in / squish with fingers to form a lot of surface area. Is there a black edge on it (combusted)?
Then heat again but be conservative, a second past the click, and try again.
You should be fine.
Vape on
Okay. Hm it doesn't look black at all. Maybe it didn't even combust this time. Hm.
But if i notice it combusts during inhaling: Can i continue inhaling the smoke or should i stop inhaling?
 

MinnBobber

Well-Known Member
But if i notice it combusts during inhaling: Can i continue inhaling the smoke or should i stop inhaling?
.........................................................................................
you can continue inhaling lightly/slighty (more to clear the VC than to get a big hit) as folks have smoked (combusted) hash for centuries. It will not taste nearly as good as vaped but--hate it to go to waste.

But, take it slow so you don't combust like:
1. a session at the click (or 2 clicks really that pop close). Get any taste, light vapor?
Wait for cooldown click and:
2. 1 second past the click and what happens
3. Cooldown click and 2 seconds past click... what's that like.
Avoid combustion by dialing heat level up slowly!!!

Note that it can put out a hit that almost seems like smoke as it's so damn thick.

Suggestion: vapor is really hard to see so can you exhale over a bright table lamp?? Vapor that you cannot even see , becomes very visible with extra light. This can really help to gauge what you are getting, or not getting , for vapor.
 

Kroisbc

New Member
.........................................................................................
you can continue inhaling lightly/slighty (more to clear the VC than to get a big hit) as folks have smoked (combusted) hash for centuries. It will not taste nearly as good as vaped but--hate it to go to waste.

But, take it slow so you don't combust like:
1. a session at the click (or 2 clicks really that pop close). Get any taste, light vapor?
Wait for cooldown click and:
2. 1 second past the click and what happens
3. Cooldown click and 2 seconds past click... what's that like.
Avoid combustion by dialing heat level up slowly!!!

Note that it can put out a hit that almost seems like smoke as it's so damn thick.

Suggestion: vapor is really hard to see so can you exhale over a bright table lamp?? Vapor that you cannot even see , becomes very visible with extra light. This can really help to gauge what you are getting, or not getting , for vapor.
Okay. Thanks.
Hm.. I didn't get affected from 0,2 gram hash.
Why not? How can i get affected from hash?
 
Kroisbc,

Krazy

Well-Known Member
My M lives in my portside and never combusts.

My Omni however lives out in the shop in glassware. I use a bigshot torch on that and sometimes it partially combusts. :shrug:
 

trout_fishing_in_america

Well-Known Member
Okay. Thanks.
Hm.. I didn't get affected from 0,2 gram hash.
Why not? How can i get affected from hash?

Just (try to) vape it some more and then eat it if still no effects. Eating will have effects for sure.

How have you loaded the hash? Try a rice sized piece of hash inside of a pea sized ball of cotton. It’ll be very hard to combust with that (like torch it 5 seconds past the click- don’t do that!).

If you load the hash straight into the VC it can singe on the edge where it touches the metal, which might produce a puff of charred vapor, but that is a far cry from smoke.

Try, try again!!!
 
trout_fishing_in_america,
  • Like
Reactions: Squiby

Kroisbc

New Member
Just (try to) vape it some more and then eat it if still no effects. Eating will have effects for sure.

How have you loaded the hash? Try a rice sized piece of hash inside of a pea sized ball of cotton. It’ll be very hard to combust with that (like torch it 5 seconds past the click- don’t do that!).

If you load the hash straight into the VC it can singe on the edge where it touches the metal, which might produce a puff of charred vapor, but that is a far cry from smoke.

Try, try again!!!
I loaded it straight in cut in small pieces.
Yea a small puff of smoke or vapor came out of the VC. And at the same time the smoke started to feel more harsh, but not very harsh. So that made me think the hash combusted.
And also it took like 30 seconds of heating before it clicked, and atleast 15 seconds if i i put the cap in the flame (single torch flame), it made me worried if my VC has malfunctioning discs or something.
Every time i immediately stopped heating after the first click.

Vaped hash (several times) did look quite black, but the illumination wasn't very good in the room.

When i was cleaning the cap which has the click thing i scrubbed it a bit from the inside with a metal stick. But then i realised that maybe there is a membrane there, so i stopped.
Is there a exposed membrane on the inside of the cap? If yes: Did i damage it?
Edit: Apparently not because in this video at 1:34
the guy would have destroyed the disc.

Next weekend i will increase the total hash dosage to max 0,5 grams.
And now i know it's okay to inhale smoke from combustion (not ideal but atleast okay).
So i should get high next weekend. But have to wait a whole week until that, sigh.
 
Last edited:
Top Bottom