Increasing vapor density

[DrömmenOmFrihet]

I’ve been doing research on how to extract my herb to the maximum, and I stumbled across this video:

Is running my unit at 500° the only way to produce vapor that dense?

 

[Shit Snacks]

Probably with the extremeQ XQ2 whatever yes, I don't know if there's a way to modify with balls, but the way to get denser vapor at a lower temp is to increase the heating mass

 

[Farid]

Another big element is the dilution of the vapor with air. If your vapor path (after the heater/oven) does not seal well, or has an air intake, the vapor will be diluted with air and be thinner.

If your airpath before the heater/oven allows too much air in then you will need to set your heater to a higher temperature to produce the same vapor.

 

[DrömmenOmFrihet]

Another big element is the dilution of the vapor with air. If your vapor path (after the heater/oven) does not seal well, or has an air intake, the vapor will be diluted with air and be thinner.

If your airpath before the heater/oven allows too much air in then you will need to set your heater to a higher temperature to produce the same vapor.

How do I know if I have excess air intake, and how do I fix it?

 

[Farid]

It will depend on the vape, but in general, block off the chamber and try to pull on it. If it's fully sealed it will produce a vacuum.

 

[DrömmenOmFrihet]

https://imgur.com/a/P1H57o6

 

[DrömmenOmFrihet]

I just took back-to-back full-extraction bong hits. May G-d help me.