Recent content by Krazzykid

I'm a little confused here, how exactly are we supposed to get in contact with @RastaBuddhaTao for warranty service? Email or through the warranty tab on his website? I only ask because I have submitted three different warranty requests over the past three weeks and have yet to receive a single...

I have had multiple batteries labeled my way for months, they fit just fine in the GH.

Just number your batteries with sharpie like normal then put a small piece of clear packing tape over the top of the ink. This will prevent it from being rubbed off. It's the oils on your skin that causes it to rub off so fast.

Look closer at the picture you just posted, specifically at number 4 Charge. It tells you right there that the lights are supposed to flicker blue while discharging (drawing on it) and increase with intensity before finally turning to red when depleted. What you are claiming is a defect is...

The lights are not supposed to blink only right before it dies, it begins blinking way before that. The speed increases as the battery drops. From the manual "As it discharges, the lights will begin to flash blue with increasing intensity." This is a normal function and it begins right away, it...

For all those worried about accidental button presses, there is a very simple solution that doesn't require you to make or buy anything at all. Simply remove the battery door and flip it over. It will then be resting on the battery wrap and not make electrical contact. I simply removed the...

So I was doing some extensive battery testing today and managed to get 9 bowls of flower and a single concentrate hit before calling it quits. The battery was at 3.43v when I pulled it. I could have pushed it further but didn't want to as the battery voltage under load was probably dropping...

@Smelly Dog Contacting George sounds like the best course of action since you paid shipping for each order. They shouldn't be holding each other up then I would imagine.

IIRC, @Smelly Dog didn't you order an original glass VC along with a preorder for the omnivap in one order? If so, then it would be the preorder that's holding your order up. I would be willing to bet that you could receive that glass VC sooner if you were to email and offer to pay a second...

@AJS Milaana has me over medicated right now. I was only seeing it one way in my head.:doh:

I just want to point out to anyone reading that this advice only works if your water pipe has an 18mm joint. The stem is way too big for 14mm female, you will need an adapter for that. If your water pipe is male fitting (direct inject) then you can put silicone around the male end and it should...

I just had an amazing concentrate experience with Milaana. I placed one strand of the provided stainless steel mesh shreds into the short stem bowl (shallow screen dome side). I proceeded to load a dab large enough that I was sure the mesh couldn't possibly hold it all. Spoiler, it did. I began...

I would generally agree here about the heat, if it were a properly working cell. If the battery had the amp capacity it should have, something would have had to heat up real quick for that kind of voltage loss (hot battery, hot contacts, wires burning themselves out, etc.) If any of these...

So it seems like your heater might be on the cooler side. This would mean you are drawing less from the battery than what I am. This should cause your battery to drain slower, not faster. This may explain some of the wispier vapor (although I feel yours should still be plenty hot enough to get...

What do the leads themselves read when you touch them together? My leads read 0.6 ish themselves. So I subtract 0.6 from 0.9 and that leaves me with a resistance of 0.3(ish) for the Milaana itself.