SixStringToker
Naked member
I don't believe that most of the people reporting 800+ temps with the baller heads are actually running at 800+ temps unless they didn't stretch their coils prior to installation in which case the coil's just bleeding off heat and not fully transferring it to the titanium body. I suspect that they either have a wonky controller or coil or there's an offset in their controller that they've forgotten about.
Troy talked about needed to go over 800 for decent hits on his qaroma and he found that the outside of the body was only getting up to 500 and some change despite the controller being set to over 800. If I set my auber to 800 with the qaroma and measure the outside of the body with a surface probe, I measure 756 degrees. I think that there's something wonky with Troy's controller.
Troy talked about needed to go over 800 for decent hits on his qaroma and he found that the outside of the body was only getting up to 500 and some change despite the controller being set to over 800. If I set my auber to 800 with the qaroma and measure the outside of the body with a surface probe, I measure 756 degrees. I think that there's something wonky with Troy's controller.
Last edited: