POTV One

[Weedlike2]

Started using POTV One recently, but hard to clean bubbler. Any suggestions, I tried Iso but tough to get it to cover all the areas inside

 

[Flotsam]

considering the bubbler is connected to a vaporizer its not as bad as if you had been combusting. I wouldn't try filling w ISO except maybe at the input end, just warm soapy water.

I think the bigger problem is residual water stuck in the bubbler. It will eventually evaporate but sometimes i just have to take the torch to it and get rid of the excess.

 

[Weedlike2]

The rest of the vape is so easy to keep clean, especially if you use the dosing capsules. It's the easiest vape I've used to keep clean except for that bubbler issue. I'll try and see if the sopay water will do the trick. Thanks

 

[buzzardwhiskey]

This is kinda nuts... I just found a One vape in an "I cleaned off this table" bag that my wife handed me. In the detritus and knick-knacks was this new vaporizer (or perhaps extremely lightly used). My best guess is that her cousin left it for me after his having a bad experience.

Anyway... Little sucker is pretty great! I attach my Moose Labs to the bent stem and it'll do a number!

 

[old-fart]

Started using POTV One recently, but hard to clean bubbler. Any suggestions, I tried Iso but tough to get it to cover all the areas inside

Have you considered using a WPA and a bong rather than the bubbler mouthpiece?

 

[budski]

just used the One this morning for the 1st time in months. I did find the curved top bubbler to be very restrictive air flow and impossible to thoroughly clean so quit using them. the long dimpled glass cools well enough with more flavor, better airflow and less bulk.