i've just got my hands on a grants water bath for £20 set at 90c for 2 hrs works perfect for decarb.
Which model do you have, and what's the approximate cost of something like that? It's a scientific grade Sous-Vide! 
Those things looks nice!
Finally had some "ingredients" to use in my @DDave Cannacaps kit for the EQ again - some very pungent Amnesia
I decarbed it in the EQ with DDave's Plug in, at 210°C for 2 hours and then let it sit overnight. Today filled it into 00 gel caps and dripped some melted butter into them.
Since I put the Soy lecithin in the butter too late, it didn't dissolve, so I just filled a cap with the granules and at it with the caps - 3 of them in total (probably could've fit it into 2 though). After decarbing it measured 0.4g.
I only had a small breakfast and didn't eat several hours before taking the caps, and about 20 minutes after taking them had a cheesy lunch. I could already feel short bursts of tinglyness shortly after taking the caps, and about 1 1/2 - 2 hours later got really nicely baked.
Really an easy way to make a small load/batch for 1, or a few micro doses for the week.
Getting the dosage right however, and when to eat..that'll require more testing!
Cheers!
Did you mean Fahrenheit?
Yeah, since the fan is off, the air rises simply because it's heated, and as it rises cools down. When it reaches the sealed chamber (the DDave mod, meaning the wire is closer to the heater) it's cooled down lower, I usually end up vaping on a lower temp with my air or Nano, much lower in fact, but for making caps I find 200 - 210 a pretty good temp, depends on the moisture content of the herbs though.210C??!!?!?
Everyone has their own formula, but if you read these links, you will see that they recommend a much lower temperature.
Read down where it says "Capsules and Tinctures"
https://hightimes.com/guides/concentrated-cannabis-part-iii-looking-beyond-the-smoke/
"Pay special attention to this sentence:
Grind your dried flowers, spread them evenly on a baking sheet and put in the oven at 220°F (105°C) for 90 minutes to convert your THC-A."
If you read further down where it says "Extract Edibles"
"keep the temperature well below 245°F (118°C), as higher temps can cook off valuable cannabinoids and degrade potency."
You can also watch this video from MB. I posted it earlier a few posts up, but here it is again:
https://www.youtube.com/watch?time_continue=11&v=cvpkKWi7ti4/
They recommend 120°C for 25-30 minutes.
Hope this helps...
Yeah, I also was a bit surprised by the relatively high temperature, but since I use a maybe a bit unconventional method to decarb, it is adjusted to achieve a similar result at a lower temp.
I am trying to examine the results closely to post more detail, I didn't cook the full 2 hrs this time, and also only let it sit for about 75 minutes.
The idea is that after the heat cycle ends, the released cannabinoids seep back into the plant matter.
This then can be ingested.
It's a nice repurpose of a vape (the Arizer EQ) that I wouldn't otherwise use. If I was serious about making edibles or something like that I'd probably get something better suited
Have a nice week!
Well actually...
I got the kit for free from DDave to try, and I wrote a pretty long winded first impression /review back then haha. It's on FC somewhere.
We discussed Temps etc, and there are also pretty simple instructions included in the pack.
But I do recommend using it as a micro dosing kit.. I just ate a PBJ with a tight packed load, and about half an hour later remembered that I have to go on a field trip tomorrow, whoops!
