Discontinued Pax Vaporizer by Ploom

Status
Not open for further replies.

welderboy

its 4:20 somewhere.....
Am I the only absent minded stoner, or has anyone dumped their load into the wrong end of the pax, c'mon and fess up....lmao
 
welderboy,

VaporsVaporizer

On the Stoop
I got some PG from a ecig seller TotallyWicked. I have ordered a few things from them now and everything has shipped very fast and shipping is cheap. They also sell cheap 10ml bottles that work perfect or a small stainless flask, it's nice with a blunt needle tip all pocket friendly. I'm sure any ecig seller will have similar stuff. Look in the eliquid mixing section.
What's PG and is it the same thing that's in the packets that Ploom sells?
 
VaporsVaporizer,

prosperian

New Member
:wave:

Nice to hear others are digging the lids. I bought a lot of crap that didn't work before I stumbled upon those :lol:

I was skeptical, but you were right about lids fitting perfectly. Can't beat the pax when you're on the go and now it won't stink. Thx

prosperian-552192-albums-junk-picture2700167-pax4.JPG
 
prosperian,

vape4health

Well-Known Member
What's PG and is it the same thing that's in the packets that Ploom sells?
Propylene glycol, I believe that vaporpedia or Pax site says the packs are PG. It works but not like a magic cleaning or anything.
Have you guys tried leaving the lid ring intact, works great and holds the caps while in use. Pop the caps and slide the ring down the pax until it hits the sticker.
Thank you 2 Paces for the "Mentos Mod" I really like it.

Am I the only absent minded stoner, or has anyone dumped their load into the wrong end of the pax, c'mon and fess up....lmao
Not yet but I just got it :) I did the wrong side of my solo stem a time or two in the dark.

mod note: Please avoid back-to-back posts, use Edit instead. Two posts merged.
 

Mr.Krinkle

Shpooding Time.
I cleaned my pax springs yesterday, holy hell do those things get gross. Mine had like a hard taffy coating of black shit, works great now. I reduced the spring tension while I was in there and now my mouthpiece will never Boba Fett off the top of my pax ever again :)
 

francis

Vape enthusiasms
Am I the only absent minded stoner, or has anyone dumped their load into the wrong end of the pax, c'mon and fess up....lmao
no ... you're the only one :rolleyes:

Happened to me the other day , i was pissed but laughing at the same time .
 
francis,

kevinnphamm

New Member

2 Paces

Well-Known Member
I always wanted to do a stealth version of the Mentos lids because it seemed off to have a bright colored lid on a black Pax. I finally grabbed some black vinyl paint this weekend. Not sure how it will hold up over time, but it looks cool for now :cool:
PICT1248.jpg
 

JoeKickass

Well-Known Member
I always wanted to do a stealth version of the Mentos lids because it seemed off to have a bright colored lid on a black Pax. I finally grabbed some black vinyl paint this weekend. Not sure how it will hold up over time, but it looks cool for now :cool:
mentos_gum_photo_3x.jpg


I bet the blue one looks cool on a black Pax.
 
JoeKickass,
  • Like
Reactions: 2 Paces

Scarface

New Member
New here, new to vaping, just got a Pax, and I have a question.

I've come to the conclusion in my research on the device that it works best when its finely grind and the chamber is full and packed tight.

Is there any problem with keeping the bud in there for multiple sessions throughout the day? Because I wouldnt need all that in one session. Im a bigger fan of multiple smaller sessions throughout the day.
 
Scarface,

Tweek

Well-Known Member
You can keep it in there. Just keep in mind that the way the oven works, your load continues to cook until cool down, so keep puffing till you stop seeing vapor.
 

PaxQc

Well-Known Member
Welcome here PaxQC ,

Viens-tu du Québec?

for the bong adapter , what is you bong joint size ?

Ouaip! jai pas encore le bucket avec le tube (la vendeuse a oublier dme le donner)

New here, new to vaping, just got a Pax, and I have a question.

I've come to the conclusion in my research on the device that it works best when its finely grind and the chamber is full and packed tight.

Is there any problem with keeping the bud in there for multiple sessions throughout the day? Because I wouldnt need all that in one session. Im a bigger fan of multiple smaller sessions throughout the day.

its fine it dsnt get smelly

mod note: Please avoid back-to-back posts, use Edit instead. Two posts merged.
 
PaxQc,

Glifax

New Member
PAX water damage:

So, like an idiot, I dropped my PAX in the toilet (thankfully it was just water) while emptying the oven. Do I have any chances at all of this thing still working? I have it in a bowl of rice now. Any thoughts or suggestions?
 
Glifax,

Mr.Krinkle

Shpooding Time.
PAX water damage:

So, like an idiot, I dropped my PAX in the toilet (thankfully it was just water) while emptying the oven. Do I have any chances at all of this thing still working? I have it in a bowl of rice now. Any thoughts or suggestions?

someone in here had already accidentally submerged their pax in water and it worked fine, though I am not sure I'd want to put my mouth anywhere near anything thats been dunked in the pooper.
 
Mr.Krinkle,
  • Like
Reactions: Glifax

Glifax

New Member
I would actually recommend disassembly, it's only one screw and it doesn't void the warranty.

That way you can really dry everything off and check out the battery

Oh, I didn't even know that was possible. I'll have to dig around for some dis-assembly instructocons.

Thanks
 
Glifax,

francis

Vape enthusiasms
Ouaip! jai pas encore le bucket avec le tube (la vendeuse a oublier dme le donner)



its fine it dsnt get smelly
Malade, un autre gars du Québec avec un Pax, et en plus tu semble tripper sur la video/montage video.
j'suis de Montréal et je trippe sur la video/montage/Gopro etc.
ton bong le joint c'est du 14 ou du 18 mm ?
 
francis,

francis

Vape enthusiasms
If you buy the pax off someone does the warranty transfer
no
www.ploom.com said:
Warranty applies to original end-user purchaser only. Warranty does not apply should you purchase through a 3rd party reseller such as eBay and Craigslist. Warranty is non-transferable. Warranty only applies to devices purchased at any authorized retailer serviced by an authorized Ploom distributor. For questions regarding authorized retailers, please contact us via email or chat at www.Ploom.com/Support.
 
francis,

OnBreak

New Member
I just use wooden skewers, I feel metal scratches stuff if ur not careful or heavy handed or too stoned

Do you have to pack the pax bowl fully?


Dang I have a chance to buy one for $150

Are they reliable or do they mess up alot ?

I like having two it's pretty damn awesome. The only down side is when you kill both in one night. :lol: Its pretty sweet bringing two and a charger to my buddies, I'll alternate and just leave one plugged in all the time, its a definite solution to looking for a home model(in that you dont have to worry about power as long as you are near an outlet), and their still portable.:D:rockon:

How long does it take to charge can you use it while charging... Is the pax as powerful as a plug
In vape?

Looking at a pax or an ascent!

mod note: Please avoid back-to-back posts, use Edit instead. Three posts merged.
 
OnBreak,

2 Paces

Well-Known Member
Do you have to pack the pax bowl fully?

No. You can get good results with less than a full oven.

I have a chance to buy one for $150

Are they reliable or do they mess up alot ?

That's a tough one to answer. Do you feel lucky?

I like having the warranty. I've owned 2 Pax for almost a year and have had to send one back for a replacement in that time. So if I had tried to save the $100 like you are considering, I would be out $150 after less than a year. It's also nice knowing I still have nine years of warranty left.

How long does it take to charge can you use it while charging...

Mine usually take about 1 hour and ten minutes to charge. I do not fully deplete the batteries to the point where the unit won't power up, but I do wait until it is flashing red when you shake it (indicating low battery).

Pax cannot be used while charging.
 
2 Paces,

stevewrightxo

Well-Known Member
Look what I did
null_zpsdb126204.jpg

null_zps3f0740ae.jpg


Some epoxy and some plastic paint not nessisarily in that order and I think it will button up


Such a good idea! I'm looking at getting some stickers with some bull shit like you find on the back of an iphone with fcc details and storage capacity, won't stand up to police etc. but makes it way more stealth, I'l try this too, always thought it would look so stealth with headphones!
 
stevewrightxo,

OnBreak

New Member
No. You can get good results with less than a full oven.



That's a tough one to answer. Do you feel lucky?

I like having the warranty. I've owned 2 Pax for almost a year and have had to send one back for a replacement in that time. So if I had tried to save the $100 like you are considering, I would be out $150 after less than a year. It's also nice knowing I still have nine years of warranty left.



Mine usually take about 1 hour and ten minutes to charge. I do not fully deplete the batteries to the point where the unit won't power up, but I do wait until it is flashing red when you shake it (indicating low battery).

Pax cannot be used while charging.


Yea might be better to just buy it new and have the 10 year warranty as peace of mind!
 
OnBreak,

Shadowdjinni

Active Member
New here, new to vaping, just got a Pax, and I have a question.

I've come to the conclusion in my research on the device that it works best when its finely grind and the chamber is full and packed tight.

Is there any problem with keeping the bud in there for multiple sessions throughout the day? Because I wouldnt need all that in one session. Im a bigger fan of multiple smaller sessions throughout the day.
I do this all the time. I drive to work while it's on Low, vape for about 10 minutes and then turn it off. It then sits in my pocket for about 5-8 hours before I go home and finish it on Medium and High.

No problems yet. Though it does kinda suck to have a half-started chamber instead of a fresh one.
 
Status
Not open for further replies.
Top Bottom