Guys to use Shatter type material you would need a great deal of heat. These are a little more stubborn then regular wax types that are easily turned into liquid when heated.
Discontinued Omicron Vaporizer for oils
- Thread starter THC SCIENTIFIC
- Start date
syrupy
Authorized Buyer
What is a 5.0 ohm or 2.4 cart?
5 ohms are for higher voltage devices like the persei that can operate at 7.4v
2.4 ohm are for devices that use 3.7v
The higher the number in ohms the higher the voltage, lower number in ohms you would need lower volts.
syrupy
Authorized Buyer
Cool, I've never seen an Ophos, so that's good to know. I've only fouled out the 5.0 ones. Didn't know it was possible with 2.4.
Caligula
Maximus
Those carts have two heaters. It sounds like one of them (upper?) heater died on you. I like to suggest people use less viscous meds when learning these carts. Essier to load and prime and hit. I like the Organalabs C02 syringes for those carts if you have access to them (CA, WA, and CO)... Although by its very nature any legit co2 oil should work nicely.
ataxian
PALE BLUE DOT
I use carts with CO2 oil.
My K.I.S.S. cart seems to handle the SHATTER as does the HERCULES SR71.
I like BLONDE CRUMBLE as well and load this in a 2.4 cart with no problem.
I used the 5.0 carts with SHATTERS with out trouble as well. (2 x AW IMR 18350's)
The OMICRON or O-PHOS with 2.4 carts filed with CO2 Oil work fine!
Even Crumble.
Some like the 1.5 carts I have never tried.
If I'm doing something wrong please correct me!
VAPORIZER22
Well-Known Member
Hey THC,
I am interested in getting some KISS carts for my V1 and Omicron V2.5 in chrome. Do you anticipate getting more in stock in the next month or so? Thanks
I am interested in getting some KISS carts for my V1 and Omicron V2.5 in chrome. Do you anticipate getting more in stock in the next month or so? Thanks
@VAPORIZER22 we have them right now all colors for the Omicron v2.xx and for the v1 we have black and chrome.
We stocked and ready to rock and roll.
VAPORIZER22
Well-Known Member
Right on, I was on the site earlier and it said chrome was sold out for the Ophos and V 2.5, I will check again.
give me a second let me update.
VAPORIZER22
Well-Known Member
No problem, Thanks!
done.
You mean the Okeanos? or just the kiss Ti Gr2 units?
Zee007
Member
It's been about 6 days since I "thought" I was out of oil... Next cart I get I will be sure to weigh, because I just found like .2 in there 
. I have tried hitting the omicron so may times with no success (15+ everyday) and all I had to do was hold it up facing down.
I have been looking everywhere for an inside image of the cartridge, I'd like to full understand how it works.
Edit: I also heated the cartridge up several times in an attempt to get oil
. I have tried hitting the omicron so may times with no success (15+ everyday) and all I had to do was hold it up facing down.I have been looking everywhere for an inside image of the cartridge, I'd like to full understand how it works.
Edit: I also heated the cartridge up several times in an attempt to get oil
Last edited:
mystikalghost
Well-Known Member
Second this too. We are all just so impatient...
Zee007
Member
Mine flashes purple, but I think that means your battery is dead
OF
Well-Known Member
Next cart I get I will be sure to weigh, because I just found like .2 in there
I have been looking everywhere for an inside image of the cartridge, I'd like to full understand how it works.
By all means, do weigh your Omicron carts before filling and keep the weight handy. Don't load more than about .7 over this under any conditions, .5 is better for most concentrates, reload when you get to .2 since that's what's retained. This has been covered maybe a hundred times in this and the Persei threads? Too bad you didn't know, it's not a secret.
You also obviously didn't "look everywhere" for a photo of the works, I've posted this one several times, and it's been reposted by none less than G is own self:
You can see the wicks with the vaporizing heater (under the 'scab' of deposits, the ones that eventually foul the cart out). It fits in the slots of the ceramic furnace body with the bulk heater wrapped around it. These both sit at the bottom end of the flue in the bottom of the tube with the concentrate around the outside.
I'd suggest some reading for tips on using Omicron carts, lots of good stuff seems to have got past you?
Best wishes.
OF
deadheadbill
I can see clearly now the smoke is gone...
Passive-aggressive much?
OF
Well-Known Member
Well thank you very much QF!
You're welcome, glad it helped.
It's also important, I think, to watch loading. Preheating the center of the cart (above the seals) before the goods get melted down is important to keep them from cooling off and sticking part way leaving an air bubble in to block flow to the wick area. This is probably the most common new owner problem?
Stick with goods that pass the foil test, weigh dry, load half a gram preheating the center carefully, reload at .2 grams left, never run the heater dry for any reason, and carefully cool down thin oils and you'll have clear sailing.........
Regards,
OF