old-fart
Member
I just bought a Dynavap from a member here, so I haven't started Dynavapping yet, but I was at the Dollar Store and saw this plastic bowl for $1.25. I like that it has a lip on the bottom to allow a little space for a screw head. One hole drilled, a screw, a nut and a couple of washer and voila! I choose a non-pointy screw thinking it would be less likely to scratch or poke through anything. The bowl is about 6" (14.5cm) in diameter. The screw come up about 1" from the bottom of the bowl. Thoughts? Thanks.
I just extracted two power magnets from an old 3.5" hard drive, so my next project is build some sort of stand.
I just extracted two power magnets from an old 3.5" hard drive, so my next project is build some sort of stand.
