How many draws on your vapcap?

[bossman]

For the sake of the poll let's assume no water involved and a full load. In your posts I'd also like to know how long your draws are and to what extent your experience depends on your heat source.

 

[bossman]

Sorry, I should have done the poll in twos with a fourth option for 7 and over.

 

[Vaporware]

1-2 per heat cycles, usually 3 heat cycles. If it’s 1 then it’s click to click, if 2 then about half the cycle minus exhalation time.

I have done 3 per cycle a few times, but not often...I’m still learning how to get the best results though since I’ve only had it for a couple of weeks.

 

[Mr. Gweilo 420]

Different flower for different results.

 

[Squiby]

I almost always use a Ti tip. When heating with a butane jet lighter, I go through three heating cycles per load. Within each cycle I get 2-3 mouthpull draws before the cooling click.

When I use my fantastic @Pipes Skelator Induction Heater, I favor the Dip and Sip technique originated by our own wonderful and creative @phattpiggie. I heat past the click to the count of 4 one thousand. Then I take a mouthpull toke, maybe two and then insert the tip for a one one thousand, two, count. Take a toke and repeat until no more vapor is produced. The only cooling click comes after you have spent your load. I love this technique! Perfect timing and ritual for a Ti Tip.

 

[Ramahs]

Depends on how I fill it. When I pack my M from my Dynastash for using when I'm out and about during the workday I pack the bowl much tighter than when I'm using it at home. I get 6-10 hits from that.

If I'm at home and packing my bowl extremely loose by just lightly packing or packing via vacum method I only get 3-5 hits.

 

[Mulchmaker]

I usually have a three heat cycle session, and then another three heat cycle session about an hour later, and then one heat cycle before I dump the ABV tailings.

I do slow, moderate-volume lung pulls; one per heat cycle.

 

[Pustupillo]

2 big draws (till the cooling down click) every time. max 0.1g

 

[bizwaxzion]

Usually 4 rounds of sip-n-dip [what's it called with a lighter?] - load looks like french roast and I'm a happy camper.

 

[Dynavaper]

Between 3 and 5 heating cycles à 1-3 draws each depending on weed quality and moisture, as well as location of heat appliance on the cap.

 

[condor020]

always one draws each heat, depend of the stuff 5 draws usually, iam starting low in the tip at bginining when im in mood for tasting

 

[hinglemccringleberry]

I run the smallest chamber size on me Ti tip and a medium-fine grind. Works out to 0.04 give or take. Lately I use a 3 flame torch and just heat the entire cap. I do 1 draw per cycle that begins with mouthpulls and ends with a lungpull. After 4 or 5 of those, the load is toast (and so am I).

2 big draws (till the cooling down click) every time. max 0.1g

Damn. That would kill me lol