Did I blow the cartridge coil?

calyx

Active Member
I have an Innokin T22 vape mod and today I bought a vape cartridge from a dispensary (the clear concentrates cartridge) and figured it would work fine because its the same connection type. I tested it when the battery was dying but I got a few decent hits. Then I tried it again later when I fully charged the battery and now it just keeps blinking a green light 4 times when I hit the button and no vapor is produced.
When I switch the tank to my other non-thc e liquid tank it works fine.

Is the T22 too much power for the thc cartridges that dispensaries sell?
 
calyx,

Detonator

Well-Known Member
make sure the center pin on the atty didnt just get pushed in,,, it's the positive post in the middle.. Sometimes they get pushed in and can be pulled back out slightly to make contact
 
Detonator,

SamuraiSam

Extraction Technician
T22 looks like it outputs 14 watts designed specifically for its own cartridge. Can you adjust the power level on it? It doesn't appear to be a standard issue 3.7V battery.

The pre filled cartridges are designded to run at 3.7V.
 
SamuraiSam,
Top Bottom