Mribisback_
Well-Known Member
My local vape shop had this Vandy Vape Mesh RDA on clearance for $10 so I picked it up for some fuckering about.
Here's what I ended up with. This has a heatsink included here but it is SMALL. About the height of an impcognito with the heatsink. The diamer is bigger at 24mm.
It came with these mesh coils I didn't have too much luck with.
I'll keep messing with it but this big vertical coil is working very well for now.
I "made" the mouthpiece myself.
No lathe needed, but I did need a drill, a hand saw, and some sandpaper. All I did was buy this at this local woodworking store. They're all over the US but ship as well.
I sawed it off where marked, and drilled the hole for the herb chamber. I used sandpaper to widen it out a bit. The part that fits into the RDA will require a bit of sanding to fit as well.
After this I had the obvious problem of herb falling into the heater, so I started using a potv capsule lid on my mouthpiece like this.
Overall I like it a lot. Feels like a stempod/impcognito hybrid.I'll keep messing with the mesh coils and keep y'all updated.
Here it is on my kizoku techmod SBS mod. Very compact.
Here's what I ended up with. This has a heatsink included here but it is SMALL. About the height of an impcognito with the heatsink. The diamer is bigger at 24mm.
It came with these mesh coils I didn't have too much luck with.
I'll keep messing with it but this big vertical coil is working very well for now.
I "made" the mouthpiece myself.
No lathe needed, but I did need a drill, a hand saw, and some sandpaper. All I did was buy this at this local woodworking store. They're all over the US but ship as well.
Buy Shaker Peg, Birch, 1-3/4", Tenon Dia. 1/4" 4-piece at Woodcraft
Made from the highest quality hardwoods. The perfect pegs to organize and hang, towels, belts and ties, etc.
www.woodcraft.com
I sawed it off where marked, and drilled the hole for the herb chamber. I used sandpaper to widen it out a bit. The part that fits into the RDA will require a bit of sanding to fit as well.
After this I had the obvious problem of herb falling into the heater, so I started using a potv capsule lid on my mouthpiece like this.
Overall I like it a lot. Feels like a stempod/impcognito hybrid.I'll keep messing with the mesh coils and keep y'all updated.
Here it is on my kizoku techmod SBS mod. Very compact.
Last edited: