Blowing out before clearing bubbler?

Status
Not open for further replies.

thejonny2014

Well-Known Member
With my bubbler, by the time I finally have the bubbler filled with vapor, my lungs are about full. Is it okay to blow out that air and then clear the rest of the vapor in the bubbler? Or will i lose some of the vapor?
 

Delta3DStudios

Well-Known Member
Accessory Maker
Yes, you should be fine

The most important thing to remember is that vapor condenses faster in cold water/glass - use warm water in a warm room to reduce condensation. Also don't let it sit long, less than 20 or 30 seconds - no more than minute.
 

MinnBobber

Well-Known Member
With my bubbler, by the time I finally have the bubbler filled with vapor, my lungs are about full. Is it okay to blow out that air and then clear the rest of the vapor in the bubbler? Or will i lose some of the vapor?

My suggestion, your lungs are full and the bubbler still has vapor in it: hold your hit for a few seconds, then exhale BUT only enough to make room for the bubbler vapor (like 10% of your lungs), then inhale the bubbler vapor and hold.
 

RUDE BOY

Space is the Place
I have to do the same with water tools, milk it out exhale take a breath then exhale before clearing that piece.

Never felt like the time it took to exhale and inhale once or twice would allow that much vapor to escape and if a tiny bit did get away it is still way better then coughing my ass off and wasting it that way.

:2c:...:peace:
 
Status
Not open for further replies.
Top Bottom