auber PID question / different coils

[Dejavu]

I am not one to dab much but I do want to buy a 25mm coil for a banger/coil setup

I use a flowerpot and was wondering if I would be messing anything up on the PID by connecting a 25mm coil for dabs and swapping back to 20mm

wasn't sure if it would mess with the calibration or anything. thanks!

 

[Grass Yes]

I am not one to dab much but I do want to buy a 25mm coil for a banger/coil setup

I use a flowerpot and was wondering if I would be messing anything up on the PID by connecting a 25mm coil for dabs and swapping back to 20mm

wasn't sure if it would mess with the calibration or anything. thanks!

If it has the correct pin out you will be fine. The coil size will not harm anything.

I use coils from Auber, DC, and @710Coils. Although there are other compatible ones. Here is a good article about that:

Cannabis Hardware Blog- About Enail Pinouts, Connections and Compatibility

There is no

www.cannabishardware.com

 

[Dejavu]

If it has the correct pin out you will be fine. The coil size will not harm anything.

I use coils from Auber, DC, and @710Coils. Although there are other compatible ones. Here is a good article about that:

Cannabis Hardware Blog- About Enail Pinouts, Connections and Compatibility

There is no

www.cannabishardware.com

what about a coil from aliexpress with the same pin layout?

 

[Grass Yes]

what about a coil from aliexpress with the same pin layout?

If the pin out is the same, it should work. I don't have any Ali coils but I believe other folks here do.

 

[Pcloudy]

A place called rcctools has the correct layout coils and also bangers and sic cups and all sorts of stuff for decent prices. Note I haven't actually ordered from them but it's what I found when I was in a similar position as you.