Needed parts:
-Plastic bottle Cap
-J-B Quick Weld
-Dome shaped end for pressing (Marker cap, lip stick lid, or in my case a container I had from an old atomizer)
Mix the J-B externally on a piece of paper and ensure an even consistent mix. Scoop into the bottle cap and wait until it's a putty like consistency. (about 3-4 minutes) Wet the marker cap, or whatever your going to use, and press into the hardening epoxy. Add a few drops of water around the impression and work the hole to be slightly larger around the pressed in poker. The water will work it's way around the poker so that it can be removed without it sticking.
Let harden for a couple hours before you use.
Happy modding!!
-Plastic bottle Cap
-J-B Quick Weld
-Dome shaped end for pressing (Marker cap, lip stick lid, or in my case a container I had from an old atomizer)
Mix the J-B externally on a piece of paper and ensure an even consistent mix. Scoop into the bottle cap and wait until it's a putty like consistency. (about 3-4 minutes) Wet the marker cap, or whatever your going to use, and press into the hardening epoxy. Add a few drops of water around the impression and work the hole to be slightly larger around the pressed in poker. The water will work it's way around the poker so that it can be removed without it sticking.
Let harden for a couple hours before you use.
Happy modding!!
