Search results

@FuckPyrolysis manual says to squeeze into a slightly out of round shape.

Ya, been a little tempted to grab the dremel and notch out the wood (liner actually) stem, as done on the metal stem, to get it to sit correctly.

In the vid, by the assembly section, with a diagram indicating orientation of the two dics back to back.

I think the relevant detail is the disc curve orientation as per the manual

I would suggest that the tempest is not deep enough, but when you get it down to the right depth the Flare will probably lower the wattage ... lower wattage, increased time. The carb caps that come with the wand are a fit for the Flare, no more holding the wand on the carb cap in your water...

I assume the reported length issue holds true for mounting this on a tempest stem, anyone tried the fit.

Blend 'em based on size and material, with an eye on the published material numbers.

Thought the main appeal was the sublimation functionality; which really seems to be a misnomer...

Around these parts 99% iso is behind the counter, but the lower percentage bottles are on the aisle, go figure.

phlegm? You're supposed to suck not blow. I see no such occurrence with the different torch vapes that I use on my water piece; tempest, revolve, simrell...

Just going by the wattage display output on the flare device itself. For me the flare has only indicated either 60 or 65 watts, which appears to be related to the depth as adjusted at the time of the start up sequence.

Best I get with the tempest is 60-65 w, seems dependent on depth of the Mad Heaters insert. The wand is currently the better choice, will be interesting to see if the issue can / will be addressed by Brenyo as per the other thread.

Depends, but IMO - Manufacturer Rated Max Discharge Current: 10A seems to come up short for most use cases.

Soothing Vapours in CA apparently still has some units; CP to USPS should be seamless.

The website gives a pretty clear indication of colour combinations.

Dani Fusion 2 is very good withe Flare, results with the Tempest is disappointing of course, but will be interesting to see if things can be addressed. Re: concerns some have voiced regarding the bottom plate. Cut to size, self adhesive neoprene sheet (~3mm), adhered to the plate makes a decent...

An allblack from beta#3, used daily, IIRC I have never used a torch on the unit, because the wand just works.

No wedging mom's kitchen knives in the spiral heating element.

One can also just reverse adaptor

~(half / half) of 2.5mm ZnO2 / 3.0mm SiC