Search results

Probably I agree. But why is that?

Repacking a dynavap in your use case is easy, fast and fun. You like hitting the joint, going back inside, and then a bit later, relighting it and hitting it again. With a dynavap you would hit it a couple of times dump out the bowl, go inside and do something, and then pop back out pack it in 5...

Any chance stunner heads are coming back in stock @tinctorus ? I read through this whole thread and wow. I’m excited to try one even though I’d be considered a microdoser by most users. Might be great to pass around. It would be like passing a cigar maybe… @TigoleBitties your descriptions have...

Anyone know if the copper FMJ is still being produced? It is out of stock at POTV and simerel no longer has it in their listings.

I often weigh out amount in the 0.035 range. I’d go with a capsule for your current POTV device or get a Dynavap halfbowl setup. Easiest would be the B which is already a half bowl. Lightly filled with fluffy fresh ground botanicals would be about 0.025. I can usually feel the clic. Cost is very...

Type 1 is basically all THC(a). Type 2 is a blend of THC(a) and other Canabinoids like CBD(a) or CBC, etc. usually the THC is 4 - 14 % or so in type 2, so usually you need to consume a little more if you are used to 24% THC bud. Type 3 is CBD flower, so less than like 1% THC(a). Sometimes people...

My favorite are the type 2 flowers, which are easy to get via the THCa vendors. Straight up they are nice and balanced; mix in a little with some type 1 and they are much more complex and interesting than type 1 alone. I think it is the other cannabiniods that are present that enrich the...

Very nice setup!

I love this thread as I am in about the same place as the OP. I’m running a TM2 and have been eyeing the phase 3 ZX. I use small amounts mostly around the weekends and share with my partner almost all of the time. We also are quite mobile around the house partaking in the hot tub, on the couch...

What is the size of the joint? 18mm or 14mm?

I was also finding that the later hits on my TM2 were harsh and something that correlated with higher temps…but then I added a finer mesh screen and worked in some ball cooling and harshness is all gone. I was mobilizing but of tricombs in the pure convection wind stream…could even see them. Now...

Sounds like you are ready to try it without the capsule…

It’s not surprising that the top two picks are 0.05 and 0.1. A dynavap basically holds 0.1 or 0.05 (for the B or half bowl) and for me at least stuffing more than 0.13 into a TM2 stem feels like it might lose out on some efficiency. I’d rather come back for more in another sesh.

I’ve tried to just dribble it in and that does work but not a well as getting a fine coating across all of the balls. Also it is just too easy to pull out the herb screen and rinse with water then blow out all the excess. There is a bit of flavor loss as you might expect, but not that much and I...

Yes. You got it. Blow out all the excess you can and then dry the rest with a sesh. :)

My new preferred drying method is to just have a couple of bowls. I’ve moved to cleaning right before a sesh with ball filled stems. Any extra water left after rinsing away the iso provides extra hydration for the vapor and extra cooling by distributing the heat around the piece better as the...

I use edibles a lot but never tinctures. Sounds like similar issues. First dose is great. The redosing is hard to nail down (again I sometimes am not sure it kicks in on the re-dose). But I love the longevity. I also use small amounts (3mg) so that could be a factor. I also though mix in vaping...

Nicely put ! The noids are also in a mixture with more volatile compounds so that too can accelerate the evaporation of the noids at temperatures below their boiling points (those typically listed I believe are measured at low pressure, so they are actually much higher at atmospheric pressure).

For myself, I like to mix edibles in for a number of reasons, but also it reducers the number of times DHvaping. I find that once dialed in I am able to take an edible and vape at the same time and then as the vape high is fading the edible high is coming on and it’s like that one session on the...

The default calibration (from the factory) with the dial on the bottom set at 4 in On-Demand mode.