Search results

The more I use other vapes the more I think this is the best you can buy. So long as you’re OK dealing with crucibles and the heatsink, I don’t see how someone could not like it.

But Oregon is way cooler that California.

Which reminds me, apparently you’re supposed to just place those chamber screens at the bottom of the bowl. Raise your hands if you figured that one out...

Though I don’t dislike the Tera, I think I’m going to return it. As we go on I’m just not OK with how Boundless is handling (or not handling) the issues the community has surrounding the device. The more that comes up, and they’re just radio silent. I will also say that the vapor is just too...

Right, I was just posing that if someone ran a bowl through it, then emptied it out, they’d likely see some vapor from whatever residue is left in there.

Heat is certainly retained by the stainless steel bowl though.

And there’s no residue in there at all?

Anyone tried different batteries in theirs?

I submitted a ticket with them asking about the chamber screens.

Some of the earliest purchasers are testers.

I’ll say that I got one of the new mouthpieces and oh man is this thing good.

They give you chamber screens and the instructions reference that, but how would you even change it? I don’t see an obvious way to remove and replace.

I do think I like the glass mouthpiece more. The vapor is warmer, but I don’t think it’s anything beyond something you’d get with an Arizer. Actually get Arizer vibes from this in a couple ways.

I didn’t experience anything like that.

Mine gets quite warm as well, not to a uncomfortable level though.

The white paper I read indicated that it’s thermally stable up to 680F.

I received an email from Puffitup: Though I would pass this along. Based on this I would presume they used Teflon AF 2400.

Same here. I’m probably on the lower end of the concern spectrum, but it’s definitly troubling.

I finally felt like I had to deep clean it. I’ve been using concentrates in it quite a bit lately. Fortunately, it’s really straightforward to disassemble and reassemble. I used a needle on the clogged holes and ISO soaked the disk. I have to say I think I’m noticing an airflow improvement.

Pack too tight? Fine grind?