Search results

Even that can be fixed cheaply, re-wrap and shrink with a hair dryer if damaged. That is what I use, the V3P WPA and straight shot glass mouthpiece both use a mesh now instead of that disc filter from the factory. Some may like the plate due to it adding a little bit of conduction, options are...

That is because 3x clicks enters the Puff Count screen, a lot of ecigs use 5x clicks...still bit of a pain! Yes, the vapor only travels over a small part of this, from the top of the CU seal until it gets to the cooling spiral that has a s/s sleeve. You can bypass it altogether with the new...

Goin off!

I swapped out the flat disc filter for a Ti mesh DDave DV screen and it rarely needs more than a brush to keep clear. The smell will dissipate as the silicon finishes curing, @His_Highness link is a great bit of advice to speed the process if your unit is newer off the production line and has...

I got an Aliexpress Ti job and it is great...and pretty cheap. https://www.aliexpress.com/item/1005004790853876.html?spm=a2g0o.order_list.0.0.f4ed18022ItfFl If I was in the US I would probably go the B0 route but shipping costs were very high to Oz.

Those e-slurpers do look interesting,

You should get about 2 years of full-on performance without looking after them, after that, they do not just die, the capacity just slowly drops off. I always buy LG HG2 or Sony VT6 as they can power just about anything with their high CDR (Continuous Discharge Rate) but next time I am going to...

Which dishes?

Welcome to the club! They are for the cooling unit, not really needed. It is a good idea to fully charge new lithium batteries before first use in any device. To get the most extended life from an 18650 is to stay between 50-80%. That said, I quite often deplete mine completely and always...

Just caught up with Pennyworth and thought it was pretty good. Could not work out where I had seen the character Bet Sykes. She is Paloma Faith and has a great set of pipes on her...I keep waiting for her to say "Fooks Sake" She is a good bad guy!

Bloody Queenslanders...that is what XXXX and Bundie will do to you.:lol:

At the bottom of the page it says, SUBSCRIBE/SIGN UP, https://shopnorthoftoronto.ca/

I get what you are hinting at...cheeky bugger:lol:, I only just got mine!

The new Roffu mouthpiece/wpa allows for less silicon in the vapor path and only acts as a seal between glass pieces, airflow and flavour both go up a bit...along with heat but good clouds are found as low as 160c/320f for me but I usually sit on 180c unless on a water piece.. Any 10mm (and a bit...

Great suggestion, wish I had thought of it!

https://vapenorth.ca/pages/search-results?q=water+pipe

Is that for people that do not like chromium?

Here you go, https://xvapeusa.com/product/roffu-glass-water-pipe-adaptor/ It is only minor, but I am sure there is a slight difference. Me neither, most stuff I have is about 12mm but a DV M body is close and would open up airflow a bit with its thinner walls and larger ID than the standard...

I too find a little more restriction, not 2 or 3x though. You can adjust the airflow by having more or less intake holes open on the glass depending on the height. The following shows the position for the highest flow rate that I have found, A straight shot from the oven into the glass plus...