Search results

Thank @psychonaut for reminding me. dp-rp37 have started on prime, only 50pcs in promotion. I am not sure how long it will last. We also provide randomly free gift of bamboo dab tool kits as below dp-dt1 https://www.dabpress.com/products/dp-dt1-dab-tools

Dabpess' temp controller box: Sensor(probes) And Heating Rod Separated To Obtain Accurate Temp We have tested our temp controller 2-3 times in factory, but it still need more time to adapt rosin plates.

What is a PID temperature controller? (From google.com) The controller would then send a signal to increase the applied heat to raise the temperature back to the setpoint. However, once the temperature reaches setpoint, the heater will again kick in. Unlike ON/OFF control, PID control...

No speech in the video, sorry for that. I will post setting instruction tomorrow and how to adapt to ambient temperature via resetting, Thank you!

How to calibrate your PID temp controller

Great

Have a great weekend to all

Usually as 20-ton hydraulic shop press, it just delivers 10-12 ton pressure easily by hand. It will be harder to achieve 15 tons. Of course, it depends hydraulic's quality. I test it with cheap one.

Thank you @psychonaut Usually buds or rosin bag is smaller than 952sq in. Finally it delivers higher than real one. You tell me a very IMPORTANT fact:clap: [952 lb/sq in] Thank you very very much! Roger

Thank @psychonaut i will add silicon mat in next shipment. Have a great day!

I still wanna write a blog about how to choose the right size of rosin press kit between 3x7″ and 4x7″. However readers is easy to be confused by my poor English. Now welcome discussion here, Thank you guys! 1, Without caged frame, just setup by screwdrivers. It means it is a little bit hard...

Caged dp-rp35s press kit will be in test. The same design with dp-rp37 but additional insulated FR4 material between heating plates and cage kit.

It is encouraging @elmomuzz love this caged press kit. I'll consider free silicon mat in the package as gift. I will share detailed PID controller SPEC here. But don't change setting if you guys don't know how. Many thanks to@fuckcombustion@psychonaut@hogni and other friends here. I'll try our...

Thank you very much! I know that.

Great:tup:

Thank you @elmomuzz

Thank you! what if pressing with micro 90 rosin bag, it helps yield?

Great , Thank you!

About durability, Temp box is key point. I will work hard on it , Thank you ! The anodizing thick of plate is 40 micron

About insulation, we have delivered a piece of bamboo block in the package. Put it under the press, It can reduce heat insulation. dp-rp35s is finished now.( it is a caged/cube kit look like dp-rp37) plate size:3x5 inch, smaller than rp37(3x7inch). @Hogni suggest me try to use FR4 between hot...