Search results

Yes

Small businesses aren’t being bailed but the billion dollar businesses that don’t need to be bailed are getting bailed. This isn’t the only small company that we will see shut down, this is the first of many many many many many many shut downs. I figured that they were liquidating when they did...

Well at least they can claim unemployment, and get the extra 600 a week (Covid bill gives USA 2 trillion in emergency fund, you get (unemployment fund) + 600)** non usa

Please don’t abandon this project :ugh:

F

Ah, you might have needed to change the resistance. That’s another factor of TC

What was your up with it in watt mode? Not enough vapor? Maybe you were drawing too fast too slow? When in watts, you change the temp using your draw speed. But when in TC mode, the temperature is consistent, but you can change draw speed and the watts will automatically go to what it needs to...

It was the condescending-ness, not the information

:nod: yes you can change it. I have the timber elite which has a mesh coil, so I do in fact know about mesh coils. A mesh coil has high surface area. But little mass. glowing kanthal is no concern; however, glowing ss is. The glowing is no big deal. The reason why you need to run your...

Yeah you can bend the coil closer to the middle if it’s too close to the wood you can see how fucked mine is

You need higher watts when the mass is low. Less watts when the mass is high. And you can’t run tcr with kanthal. A mesh heater is the opposite of beefy.

My char is much worse, you can see it on the outside of the wood. On the inside it looks all carbonized and crackly. I think you'll be fine, because yours is waaaaaaaaaaaaaay lighter than mine.

I think its much easier to tighten the coil when its spread out as you can get more grip on the top coil. I didn't use anything on the coil so it got scratched up. I have a spare 16mm coil so I didn't care. But the scratches didn't do anything anyway. Try gripping the coil in multiple ways in...

I haven’t noticed the draw restriction. But I prefer my water pieces to be chuggier, so that’s why. I go around 650-665°F for cashing a bowl. I’m still trying to figure out a decent starting temp. Usually around 550 I’ll get good flavor. 600 for brown. I prefer my vapes to have high draw...

pull on it harder. And then put wood wax on the o rings before replacing the wood

Elev8r + Glass Beads + Coil = baked. I use it like a flower pot, until my 20mm coil comes

I put a flat head between the coil and twisted. That’s how I spread it. Then I grabbed pliers and twisted it clockwise.

https://myvpro.com/products/staple-alien-performance-prebuilt-coils-by-coilology, you need a 5/32” Allen wrench

control: 46w initial heat - 1.5s Draw speed can over power coil Cools down quick new: 46w https://myvpro.com/products/staple-alien-performance-prebuilt-coils-by-coilology initial heat - 9.5s Needs heat for 1 sec each press Can rip like tetrax (tetrax also has glass between the coils for more...

Cool. To all of the people who bash because it’s close to a dynavap, competition leads to innovation. Dynavap hasn’t made anything new in a long time. This could be a competitor, and will also work with current stems.